[PATCH 18/20] iwlwifi: remove redundant condition from prior alive dump flow

[Luca Coelho <luca@coelho.fi>]

From: Shahar S Matityahu <shahar.s.matityahu@intel.com>

After the FW image was loaded for the first time,
fwrt->smem_cfg.num_lmacs value will no longer be zero since we don't
clean it when we stop the device. So if we load the image once and then
we fail on a consecutive attempt, the driver will abort any dumping.

Solve this by removing the condition. It is safe to remove since
when we do the actual dumping in iwl_fw_dbg_collect_sync we check
that STATUS_DEVICE_ENABLED bit is still active.

Signed-off-by: Shahar S Matityahu <shahar.s.matityahu@intel.com>
Signed-off-by: Luca Coelho <luciano.coelho@intel.com>
---
 drivers/net/wireless/intel/iwlwifi/fw/dbg.c | 16 ----------------
 1 file changed, 16 deletions(-)

diff --git a/drivers/net/wireless/intel/iwlwifi/fw/dbg.c b/drivers/net/wireless/intel/iwlwifi/fw/dbg.c
index 202f96e9ca0c..b189a605ec13 100644
--- a/drivers/net/wireless/intel/iwlwifi/fw/dbg.c
+++ b/drivers/net/wireless/intel/iwlwifi/fw/dbg.c
@@ -1592,22 +1592,6 @@ int iwl_fw_dbg_collect_desc(struct iwl_fw_runtime *fwrt,
 			    bool monitor_only,
 			    unsigned int delay)
 {
-	/*
-	 * If the loading of the FW completed successfully, the next step is to
-	 * get the SMEM config data. Thus, if fwrt->smem_cfg.num_lmacs is non
-	 * zero, the FW was already loaded successully. If the state is "NO_FW"
-	 * in such a case - exit, since FW may be dead. Otherwise, we
-	 * can try to collect the data, since FW might just not be fully
-	 * loaded (no "ALIVE" yet), and the debug data is accessible.
-	 *
-	 * Corner case: got the FW alive but crashed before getting the SMEM
-	 *	config. In such a case, due to HW access problems, we might
-	 *	collect garbage.
-	 */
-	if (fwrt->trans->state == IWL_TRANS_NO_FW &&
-	    fwrt->smem_cfg.num_lmacs)
-		return -EIO;
-
 	if (test_and_set_bit(IWL_FWRT_STATUS_DUMPING, &fwrt->status))
 		return -EBUSY;
 
-- 
2.20.1