[RESEND PATCH v4] iwlwifi: mvm: adding check if the thermal firmware is running

[Guilherme Giacomo Simoes <trintaeoitogc@gmail.com>]

In the dmesg is showing the message "failed to read out thermal zone"
as if the temperature read is failed by don't find the thermal zone.

After researching and debugging, I see that this specific error is
occurrenced because the thermal try read the temperature when is started,
but the firmware is not running yet.

For more legibiliti i change the tt.c for return EAGAIN when this was occurrence.
After this change, in my computer I compile and install kernel in /boot
and in my dmesg the message "failed to read out thermal zone" is not show
any more.

I would like to thanks for Rafael Wysocki <refael.j.wysocki@intel.com> ,
Kalle Valo <kvalo@kernel.org> and Johannes Berg <johannes@sipsolutions.net>
for your suggestions in my previous patch.

Signed-off-by: Guilherme Giacomo Simoes <trintaeoitogc@gmail.com>
---
 drivers/net/wireless/intel/iwlwifi/mvm/tt.c | 8 ++++++--
 1 file changed, 6 insertions(+), 2 deletions(-)

diff --git a/drivers/net/wireless/intel/iwlwifi/mvm/tt.c b/drivers/net/wireless/intel/iwlwifi/mvm/tt.c
index 8083c4b2ab6b..d1dd334b5049 100644
--- a/drivers/net/wireless/intel/iwlwifi/mvm/tt.c
+++ b/drivers/net/wireless/intel/iwlwifi/mvm/tt.c
@@ -620,8 +620,12 @@ static int iwl_mvm_tzone_get_temp(struct thermal_zone_device *device,
 
 	mutex_lock(&mvm->mutex);
 
-	if (!iwl_mvm_firmware_running(mvm) ||
-	    mvm->fwrt.cur_fw_img != IWL_UCODE_REGULAR) {
+	if (!iwl_mvm_firmware_running(mvm)) {
+		ret = -EAGAIN;
+		goto out;
+	}
+
+	if (mvm->fwrt.cur_fw_img != IWL_UCODE_REGULAR) {
 		ret = -ENODATA;
 		goto out;
 	}
-- 
2.45.2