[PATCH 5/5] wifi: mt76: mt7996: fix queue pause after scan due to wrong channel switch reason

[Shayne Chen <shayne.chen@mediatek.com>]

From: StanleyYP Wang <StanleyYP.Wang@mediatek.com>

Previously, we use the IEEE80211_CONF_IDLE flag to avoid setting the
parking channel with the CH_SWITCH_NORMAL reason, which could trigger TX
emission before bootup CAC.

However, we found that this flag can be set after triggering scanning on a
connected station interface, and the reason CH_SWITCH_SCAN_BYPASS_DPD will
be used when switching back to the operating channel, which makes the
firmware failed to resume paused AC queues.

Seems that we should avoid relying on this flag after switching to single
multi-radio architecture. Instead, replace it with MT76_STATE_RUNNING.

Signed-off-by: StanleyYP Wang <StanleyYP.Wang@mediatek.com>
Signed-off-by: Shayne Chen <shayne.chen@mediatek.com>
---
 drivers/net/wireless/mediatek/mt76/mt7996/mcu.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/net/wireless/mediatek/mt76/mt7996/mcu.c b/drivers/net/wireless/mediatek/mt76/mt7996/mcu.c
index 68d698033e43..1d5ea28e7b9b 100644
--- a/drivers/net/wireless/mediatek/mt76/mt7996/mcu.c
+++ b/drivers/net/wireless/mediatek/mt76/mt7996/mcu.c
@@ -3925,7 +3925,7 @@ int mt7996_mcu_set_chan_info(struct mt7996_phy *phy, u16 tag)
 	if (phy->mt76->hw->conf.flags & IEEE80211_CONF_MONITOR)
 		req.switch_reason = CH_SWITCH_NORMAL;
 	else if (phy->mt76->offchannel ||
-		 phy->mt76->hw->conf.flags & IEEE80211_CONF_IDLE)
+		 !test_bit(MT76_STATE_RUNNING, &phy->mt76->state))
 		req.switch_reason = CH_SWITCH_SCAN_BYPASS_DPD;
 	else if (!cfg80211_reg_can_beacon(phy->mt76->hw->wiphy, chandef,
 					  NL80211_IFTYPE_AP))
-- 
2.51.0