[PATCH rtw-next 03/10] wifi: rtw89: fw: lower debug level for UDM1 debug register

[Ping-Ke Shih <pkshih@realtek.com>]

The UDM1 is user define message to record count of H2C command sent by
driver and received by firmware. Normally, this value should be zero.
Otherwise, throw a warning.

For the new chip RTL8922DE, its default value is not zero, causing a
warning at first time probe. Since this is a debug purpose and the
value will be set to zero right after this checking, lower the debug level.

Signed-off-by: Ping-Ke Shih <pkshih@realtek.com>
---
 drivers/net/wireless/realtek/rtw89/mac_be.c | 6 ++++--
 1 file changed, 4 insertions(+), 2 deletions(-)

diff --git a/drivers/net/wireless/realtek/rtw89/mac_be.c b/drivers/net/wireless/realtek/rtw89/mac_be.c
index 4cb48cf9415a..d9c93adb58ee 100644
--- a/drivers/net/wireless/realtek/rtw89/mac_be.c
+++ b/drivers/net/wireless/realtek/rtw89/mac_be.c
@@ -652,8 +652,10 @@ static int wcpu_on(struct rtw89_dev *rtwdev, u8 boot_reason, bool dlfw)
 	}
 	val32 = rtw89_read32(rtwdev, R_BE_UDM1);
 	if (val32) {
-		rtw89_warn(rtwdev, "[SER] AON L2 Debug register not empty before Boot.\n");
-		rtw89_warn(rtwdev, "[SER] %s: R_BE_UDM1 = 0x%x\n", __func__, val32);
+		rtw89_debug(rtwdev, RTW89_DBG_UNEXP,
+			    "[SER] AON L2 Debug register not empty before Boot.\n");
+		rtw89_debug(rtwdev, RTW89_DBG_UNEXP,
+			    "[SER] %s: R_BE_UDM1 = 0x%x\n", __func__, val32);
 	}
 	val32 = rtw89_read32(rtwdev, R_BE_UDM2);
 	if (val32) {
-- 
2.25.1