Re: [PATCH] mac80211: Add module parameter for setting initial rate in rc80211_simple

[Larry Finger <larry.finger@lwfinger.net>]

Jiri Benc wrote:
> 
> Don't misuse module parameters, please. If you have more devices, this
> single parameter will affect all of them. That's not a good approach,
> especially when the value you are trying to change can be changed on
> the fly.
--- snip ---
> However, I'm not against setting the initial value to the lowest rate
> available. As Johannes pointed out, if the rate control algorithm isn't
> able to quickly migrate to higher rates, it's a good candidate for
> rewrite.

I'm more than a little confused. First you tell me that setting the initial rate with a module 
parameter is bad because it sets a value for all _MY_ devices, then you say that you will allow a 
change that would affect _EVERYONE'S_ devices. Huh? I wrote the code the way I did because I thought 
it was much better to allow a local solution rather than a global one.

Larry