Re: Change error message for failed rc module

[Larry Finger <larry.finger@lwfinger.net>]

Michael Buesch wrote:
> On Saturday 27 October 2007 23:56:39 evan foss wrote:
> <snip>
>> ssb: Core 0 found: ChipCommon (cc 0x800, rev 0x11, vendor 0x4243)
>> ssb: Core 1 found: IEEE 802.11 (cc 0x812, rev 0x0A, vendor 0x4243)
>> ssb: Core 2 found: USB 1.1 Host (cc 0x817, rev 0x03, vendor 0x4243)
>> ssb: Core 3 found: PCI-E (cc 0x820, rev 0x01, vendor 0x4243)
>> ssb: Sonics Silicon Backplane found on PCI device 0000:01:00.0
>> b43-phy1: Broadcom 4311 WLAN found
>> b43-phy1 debug: Found PHY: Analog 4, Type 2, Revision 8
>> b43-phy1 debug: Found Radio: Manuf 0x17F, Version 0x2050, Revision 2
>> phy1: Failed to select rate control algorithm
>> phy1: Failed to initialize rate control algorithm
>> b43: probe of ssb0:0 failed with error -2
> 
> That's not a ssb or b43 bug.
> Please compile and load rc80211_simple.
> 
> I think we should change this error message, as obviously people don't
> understand that the issue is a failed module request for the rc module.
> Maybe add another message like "Please install a mac80211 rate control module,
> such as rc80211_simple" if the error code is -ENOENT (-2)
> Another suggestion?

Your suggestion looks good to me.

Larry