From: Ping-Ke Shih <pkshih@realtek.com>
To: Bitterblue Smith <rtl8821cerfe2@gmail.com>,
"linux-wireless@vger.kernel.org" <linux-wireless@vger.kernel.org>
Subject: RE: [PATCH 14/20] wifi: rtw88: 8821a: Regularly ask for BT info updates
Date: Thu, 15 Aug 2024 07:26:30 +0000 [thread overview]
Message-ID: <477a1603b5cd454aa82f186bc88b73e3@realtek.com> (raw)
In-Reply-To: <bd23d618-3f56-4729-ba23-8c14e9873ef9@gmail.com>
Bitterblue Smith <rtl8821cerfe2@gmail.com> wrote:
> The RTL8821AU firmware sends C2H_BT_INFO by itself when bluetooth
> headphones are connected, but not when they are disconnected. This leads
> to the coexistence code still using the A2DP algorithm long after the
> headphones are disconnected, which means the wifi speeds are much lower
> than they should be. Work around this by asking for updates every two
> seconds if the chip is RTL8821AU.
>
> Signed-off-by: Bitterblue Smith <rtl8821cerfe2@gmail.com>
> ---
> drivers/net/wireless/realtek/rtw88/coex.c | 2 +-
> drivers/net/wireless/realtek/rtw88/coex.h | 1 +
> drivers/net/wireless/realtek/rtw88/main.c | 3 +++
> 3 files changed, 5 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/net/wireless/realtek/rtw88/coex.c b/drivers/net/wireless/realtek/rtw88/coex.c
> index 39fbc5ef82f8..91e21bdfb569 100644
> --- a/drivers/net/wireless/realtek/rtw88/coex.c
> +++ b/drivers/net/wireless/realtek/rtw88/coex.c
> @@ -446,7 +446,7 @@ static void rtw_coex_check_rfk(struct rtw_dev *rtwdev)
> }
> }
>
> -static void rtw_coex_query_bt_info(struct rtw_dev *rtwdev)
> +void rtw_coex_query_bt_info(struct rtw_dev *rtwdev)
> {
> struct rtw_coex *coex = &rtwdev->coex;
> struct rtw_coex_stat *coex_stat = &coex->stat;
> diff --git a/drivers/net/wireless/realtek/rtw88/coex.h b/drivers/net/wireless/realtek/rtw88/coex.h
> index 57cf29da9ea4..b6400e87e78d 100644
> --- a/drivers/net/wireless/realtek/rtw88/coex.h
> +++ b/drivers/net/wireless/realtek/rtw88/coex.h
> @@ -384,6 +384,7 @@ u32 rtw_coex_read_indirect_reg(struct rtw_dev *rtwdev, u16 addr);
> void rtw_coex_write_indirect_reg(struct rtw_dev *rtwdev, u16 addr,
> u32 mask, u32 val);
> void rtw_coex_write_scbd(struct rtw_dev *rtwdev, u16 bitpos, bool set);
> +void rtw_coex_query_bt_info(struct rtw_dev *rtwdev);
>
> void rtw_coex_bt_relink_work(struct work_struct *work);
> void rtw_coex_bt_reenable_work(struct work_struct *work);
> diff --git a/drivers/net/wireless/realtek/rtw88/main.c b/drivers/net/wireless/realtek/rtw88/main.c
> index 62d9abc04a34..699870ca1a9f 100644
> --- a/drivers/net/wireless/realtek/rtw88/main.c
> +++ b/drivers/net/wireless/realtek/rtw88/main.c
> @@ -261,6 +261,9 @@ static void rtw_watch_dog_work(struct work_struct *work)
> rtw_coex_wl_status_check(rtwdev);
> rtw_coex_query_bt_hid_list(rtwdev);
>
> + if (rtwdev->chip->id == RTW_CHIP_TYPE_8821A && rtwdev->efuse.btcoex)
> + rtw_coex_query_bt_info(rtwdev);
> +
Move to an individual function such as rtw_coex_active_query_bt_info() (maybe inline function),
and add a little bit comments to describe how we need this.
> rtw_phy_dynamic_mechanism(rtwdev);
>
> rtw_hci_dynamic_rx_agg(rtwdev,
> --
> 2.46.0
next prev parent reply other threads:[~2024-08-15 7:26 UTC|newest]
Thread overview: 64+ messages / expand[flat|nested] mbox.gz Atom feed top
2024-08-11 20:53 [PATCH 00/20] wifi: rtw88: Add support for RTL8821AU and RTL8812AU Bitterblue Smith
2024-08-11 20:54 ` [PATCH 01/20] wifi: rtw88: Add some definitions for RTL8821AU/RTL8812AU Bitterblue Smith
2024-08-15 6:34 ` Ping-Ke Shih
2024-08-11 20:54 ` [PATCH 02/20] wifi: rtw88: Dump the HW features only for some chips Bitterblue Smith
2024-08-15 6:10 ` Ping-Ke Shih
2024-08-19 17:51 ` Bitterblue Smith
2024-08-11 20:55 ` [PATCH 03/20] wifi: rtw88: Allow different C2H RA report sizes Bitterblue Smith
2024-08-15 6:14 ` Ping-Ke Shih
2024-08-19 17:52 ` Bitterblue Smith
2024-08-20 1:10 ` Ping-Ke Shih
2024-08-20 21:44 ` Bitterblue Smith
2024-08-21 0:31 ` Ping-Ke Shih
2024-08-21 11:13 ` Bitterblue Smith
2024-08-22 0:33 ` Ping-Ke Shih
2024-08-22 6:58 ` Kalle Valo
2024-08-22 14:04 ` Bitterblue Smith
2024-08-11 20:55 ` [PATCH 04/20] wifi: rtw88: Extend the init table parsing for RTL8812AU Bitterblue Smith
2024-08-15 6:27 ` Ping-Ke Shih
2024-08-11 20:57 ` [PATCH 05/20] wifi: rtw88: Allow rtw_chip_info.ltecoex_addr to be NULL Bitterblue Smith
2024-08-15 6:33 ` Ping-Ke Shih
2024-08-19 17:53 ` Bitterblue Smith
2024-08-20 1:15 ` Ping-Ke Shih
2024-08-11 20:57 ` [PATCH 06/20] wifi: rtw88: Let each driver control the power on/off process Bitterblue Smith
2024-08-11 20:59 ` [PATCH 07/20] wifi: rtw88: Enable data rate fallback for older chips Bitterblue Smith
2024-08-15 6:46 ` Ping-Ke Shih
2024-08-11 21:00 ` [PATCH 08/20] wifi: rtw88: Make txagc_remnant_ofdm an array Bitterblue Smith
2024-08-15 6:50 ` Ping-Ke Shih
2024-08-11 21:00 ` [PATCH 09/20] wifi: rtw88: Support TX page sizes bigger than 128 Bitterblue Smith
2024-08-15 6:52 ` Ping-Ke Shih
2024-08-11 21:01 ` [PATCH 10/20] wifi: rtw88: Move pwr_track_tbl to struct rtw_rfe_def Bitterblue Smith
2024-08-15 7:00 ` Ping-Ke Shih
2024-08-11 21:02 ` [PATCH 11/20] wifi: rtw88: usb: Set pkt_info.ls for the reserved page Bitterblue Smith
2024-08-15 7:07 ` Ping-Ke Shih
2024-08-11 21:02 ` [PATCH 12/20] wifi: rtw88: Detect beacon loss with chips other than 8822c Bitterblue Smith
2024-08-15 7:16 ` Ping-Ke Shih
2024-08-11 21:03 ` [PATCH 13/20] wifi: rtw88: coex: Support chips without a scoreboard Bitterblue Smith
2024-08-15 7:19 ` Ping-Ke Shih
2024-08-11 21:04 ` [PATCH 14/20] wifi: rtw88: 8821a: Regularly ask for BT info updates Bitterblue Smith
2024-08-15 7:26 ` Ping-Ke Shih [this message]
2024-08-11 21:05 ` [PATCH 15/20] wifi: rtw88: 8812a: Mitigate beacon loss Bitterblue Smith
2024-08-15 7:31 ` Ping-Ke Shih
2024-08-11 21:06 ` [PATCH 16/20] wifi: rtw88: Add rtw8812a_table.{c,h} Bitterblue Smith
2024-08-15 7:53 ` Ping-Ke Shih
2024-08-16 1:19 ` Ping-Ke Shih
2024-08-11 21:06 ` [PATCH 17/20] wifi: rtw88: Add rtw8821a_table.{c,h} Bitterblue Smith
2024-08-15 7:55 ` Ping-Ke Shih
2024-08-11 21:07 ` [PATCH 18/20] wifi: rtw88: Add rtw8821a.{c,h} Bitterblue Smith
2024-08-16 6:06 ` Ping-Ke Shih
2024-08-27 17:52 ` Bitterblue Smith
2024-09-10 2:30 ` Ping-Ke Shih
2024-09-12 15:59 ` Bitterblue Smith
2024-09-13 1:50 ` Ping-Ke Shih
2024-09-21 22:47 ` Bitterblue Smith
2024-09-23 5:47 ` Ping-Ke Shih
2024-09-23 5:58 ` Ping-Ke Shih
2024-09-24 21:19 ` Bitterblue Smith
2024-09-25 1:25 ` Ping-Ke Shih
2024-09-25 11:28 ` Bitterblue Smith
2024-09-26 2:27 ` Ping-Ke Shih
2024-09-26 16:41 ` Bitterblue Smith
2024-08-11 21:08 ` [PATCH 19/20] wifi: rtw88: Add rtw8821au.c and rtw8812au.c Bitterblue Smith
2024-08-15 7:58 ` Ping-Ke Shih
2024-08-11 21:11 ` [PATCH 20/20] wifi: rtw88: Enable the new RTL8821AU/RTL8812AU drivers Bitterblue Smith
2024-08-15 8:01 ` Ping-Ke Shih
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=477a1603b5cd454aa82f186bc88b73e3@realtek.com \
--to=pkshih@realtek.com \
--cc=linux-wireless@vger.kernel.org \
--cc=rtl8821cerfe2@gmail.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).