* Which firmware for Belkin F5D7050 (ISL3880 + NET2280) @ 2009-06-07 11:22 Wojciech Zabolotny CERN 2009-06-07 12:29 ` Wojciech Zabolotny CERN 0 siblings, 1 reply; 3+ messages in thread From: Wojciech Zabolotny CERN @ 2009-06-07 11:22 UTC (permalink / raw) To: linux-wireless Hi, I have the Belkin F5D7050 WiFi card with the following chips: 1. NET2280 REV1A-LF 2. ISL3880IK Which firmware should I use? It seemed to me, that the proper choice is the: USB 1st generation (ISL3886 + net2280) isl3886usb download <http://daemonizer.de/prism54/prism54-fw/fw-usb/2.13.24.0.lm86.arm> However, when I try to use it, I get the following info in my logs: usb 1-5: firmware: requesting isl3886usb phy3: p54 detected a LM86 firmware p54: rx_mtu reduced from 3240 to 2392 phy3: FW rev 2.13.24.0 - Softmac protocol 5.9 phy3: cryptographic accelerator WEP:YES, TKIP:YES, CCMP:YES p54usb: probe of 1-5:1.0 failed with error -110 usbcore: registered new interface driver p54usb Is this problem associated with the incorrect firmware version or with something else? -- TIA & BR, WZab ^ permalink raw reply [flat|nested] 3+ messages in thread
* Re: Which firmware for Belkin F5D7050 (ISL3880 + NET2280) 2009-06-07 11:22 Which firmware for Belkin F5D7050 (ISL3880 + NET2280) Wojciech Zabolotny CERN @ 2009-06-07 12:29 ` Wojciech Zabolotny CERN 2009-06-07 12:59 ` Gábor Stefanik 0 siblings, 1 reply; 3+ messages in thread From: Wojciech Zabolotny CERN @ 2009-06-07 12:29 UTC (permalink / raw) To: linux-wireless Hi, I've managed to run my NIC with the older firmware: http://daemonizer.de/prism54/prism54-fw/fw-usb/2.13.1.0.lm86.arm Now I get the following output in dmesg: cfg80211: Using static regulatory domain info cfg80211: Regulatory domain: US (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) (2402000 KHz - 2472000 KHz @ 40000 KHz), (600 mBi, 2700 mBm) (5170000 KHz - 5190000 KHz @ 40000 KHz), (600 mBi, 2300 mBm) (5190000 KHz - 5210000 KHz @ 40000 KHz), (600 mBi, 2300 mBm) (5210000 KHz - 5230000 KHz @ 40000 KHz), (600 mBi, 2300 mBm) (5230000 KHz - 5330000 KHz @ 40000 KHz), (600 mBi, 2300 mBm) (5735000 KHz - 5835000 KHz @ 40000 KHz), (600 mBi, 3000 mBm) cfg80211: Calling CRDA for country: US usb 1-4: firmware: requesting isl3886usb phy0: p54 detected a LM86 firmware p54: rx_mtu reduced from 3240 to 2392 phy0: FW rev 2.13.1.0 - Softmac protocol 5.5 phy0: cryptographic accelerator WEP:YES, TKIP:YES, CCMP:YES phy0: hwaddr 00:30:43:11:33:39, MAC:isl3886 RF:Frisbee wmaster0 (p54usb): not using net_device_ops yet phy0: Selected rate control algorithm 'minstrel' wlan0 (p54usb): not using net_device_ops yet usbcore: registered new interface driver p54usb Then everything works correctly. So it seems, that the new firmware is just incompatible with this card :-(. -- BR, WZab ^ permalink raw reply [flat|nested] 3+ messages in thread
* Re: Which firmware for Belkin F5D7050 (ISL3880 + NET2280) 2009-06-07 12:29 ` Wojciech Zabolotny CERN @ 2009-06-07 12:59 ` Gábor Stefanik 0 siblings, 0 replies; 3+ messages in thread From: Gábor Stefanik @ 2009-06-07 12:59 UTC (permalink / raw) To: Wojciech Zabolotny CERN; +Cc: linux-wireless On Sun, Jun 7, 2009 at 2:29 PM, Wojciech Zabolotny CERN<wojciech.zabolotny@cern.ch> wrote: > Hi, > > I've managed to run my NIC with the older firmware: > http://daemonizer.de/prism54/prism54-fw/fw-usb/2.13.1.0.lm86.arm > > Now I get the following output in dmesg: > > cfg80211: Using static regulatory domain info > cfg80211: Regulatory domain: US > (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) > (2402000 KHz - 2472000 KHz @ 40000 KHz), (600 mBi, 2700 mBm) > (5170000 KHz - 5190000 KHz @ 40000 KHz), (600 mBi, 2300 mBm) > (5190000 KHz - 5210000 KHz @ 40000 KHz), (600 mBi, 2300 mBm) > (5210000 KHz - 5230000 KHz @ 40000 KHz), (600 mBi, 2300 mBm) > (5230000 KHz - 5330000 KHz @ 40000 KHz), (600 mBi, 2300 mBm) > (5735000 KHz - 5835000 KHz @ 40000 KHz), (600 mBi, 3000 mBm) > cfg80211: Calling CRDA for country: US > usb 1-4: firmware: requesting isl3886usb > phy0: p54 detected a LM86 firmware > p54: rx_mtu reduced from 3240 to 2392 > phy0: FW rev 2.13.1.0 - Softmac protocol 5.5 > phy0: cryptographic accelerator WEP:YES, TKIP:YES, CCMP:YES > phy0: hwaddr 00:30:43:11:33:39, MAC:isl3886 RF:Frisbee > wmaster0 (p54usb): not using net_device_ops yet > phy0: Selected rate control algorithm 'minstrel' > wlan0 (p54usb): not using net_device_ops yet > usbcore: registered new interface driver p54usb > > > Then everything works correctly. > So it seems, that the new firmware is just incompatible with this card :-(. What about an LM87 firmware? It should be supported now... > -- > BR, WZab > > -- > To unsubscribe from this list: send the line "unsubscribe linux-wireless" in > the body of a message to majordomo@vger.kernel.org > More majordomo info at http://vger.kernel.org/majordomo-info.html > -- Vista: [V]iruses, [I]ntruders, [S]pyware, [T]rojans and [A]dware. :-) ^ permalink raw reply [flat|nested] 3+ messages in thread
end of thread, other threads:[~2009-06-07 12:59 UTC | newest] Thread overview: 3+ messages (download: mbox.gz follow: Atom feed -- links below jump to the message on this page -- 2009-06-07 11:22 Which firmware for Belkin F5D7050 (ISL3880 + NET2280) Wojciech Zabolotny CERN 2009-06-07 12:29 ` Wojciech Zabolotny CERN 2009-06-07 12:59 ` Gábor Stefanik
This is a public inbox, see mirroring instructions for how to clone and mirror all data and code used for this inbox; as well as URLs for NNTP newsgroup(s).