Re: WL1271: WLAN_IRQ not working

[Troy Kisky <troy.kisky@boundarydevices.com>]

On 6/30/2011 1:00 PM, Troy Kisky wrote:
> On 6/30/2011 12:20 PM, Krakowski, Oz wrote:
>> Troy,
>> On Thu, Jun 30, 2011 at 2:05 PM, Troy Kisky
>> <troy.kisky@boundarydevices.com> wrote:
>>> On 6/29/2011 11:24 PM, mangesh gadre wrote:
>>>> Hi,
>>>>
>>>> Please check if your wifi enable pin is in right state. secondly check if
>>>> regulator section of your chip is actually powering up wifi internal core .
>>>> check your circuit against standard ref circuit.
>>>> I have seen similar issue and there was some resistor missing in feedback
>>>> path of volatge regulator output path from chip. Most probably wifi section
>>>> of your chip is not powered up.
>>>
>>> I think the problem is solved, but can you point me to a "standard ref
>>> circuit" for TiWiR2. Maybe, I can avoid future problems.
>>
>> For the benefit of everyone, can you share what was the issue?
>>
>> Thanks,
>> Oz.
> 

Another problem was that gpio interrupts were not working on mx53
platforms on 3.0-rc4. I just submitted a patch.

Thanks
Troy