From mboxrd@z Thu Jan 1 00:00:00 1970 Return-path: Received: from mms3.broadcom.com ([216.31.210.19]:4123 "EHLO MMS3.broadcom.com" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S932091Ab2BAQKs (ORCPT ); Wed, 1 Feb 2012 11:10:48 -0500 Message-ID: <4F2963F8.9060804@broadcom.com> (sfid-20120201_171053_155434_EA08B29E) Date: Wed, 1 Feb 2012 17:10:32 +0100 From: "Arend van Spriel" MIME-Version: 1.0 To: "balbi@ti.com" cc: "stefano.brivio@polimi.it" , "linux-wireless@vger.kernel.org" , "b43-dev@lists.infradead.org" Subject: Re: Dell e6410 with b43 References: <20120201123324.GG20238@legolas.emea.dhcp.ti.com> In-Reply-To: <20120201123324.GG20238@legolas.emea.dhcp.ti.com> Content-Type: text/plain; charset=iso-8859-1 Sender: linux-wireless-owner@vger.kernel.org List-ID: On 02/01/2012 01:33 PM, Felipe Balbi wrote: > Hi all, > > is Dell e6410's b43 wireless card supported by the open source driver ? > > Here's lspci dump: > > 02:00.0 Network controller [0280]: Broadcom Corporation BCM43224 802.11a/b/g/n [14e4:4353] (rev 01) > Subsystem: Dell Wireless 1520 Half-size Mini PCIe Card [1028:000e] > Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx- > Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- SERR- Latency: 0, Cache Line Size: 64 bytes > Interrupt: pin A routed to IRQ 10 > Region 0: Memory at f4100000 (64-bit, non-prefetchable) [size=16K] > Capabilities: [40] Power Management version 3 > Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA PME(D0+,D1-,D2-,D3hot+,D3cold+) > Status: D0 NoSoftRst+ PME-Enable- DSel=0 DScale=2 PME- > Capabilities: [58] Vendor Specific Information: Len=78 > Capabilities: [48] MSI: Enable- Count=1/1 Maskable- 64bit+ > Address: 0000000000000000 Data: 0000 > Capabilities: [d0] Express (v1) Endpoint, MSI 00 > DevCap: MaxPayload 128 bytes, PhantFunc 0, Latency L0s <4us, L1 unlimited > ExtTag+ AttnBtn- AttnInd- PwrInd- RBE+ FLReset- > DevCtl: Report errors: Correctable- Non-Fatal- Fatal- Unsupported- > RlxdOrd- ExtTag- PhantFunc- AuxPwr- NoSnoop- > MaxPayload 128 bytes, MaxReadReq 128 bytes > DevSta: CorrErr+ UncorrErr- FatalErr- UnsuppReq+ AuxPwr+ TransPend- > LnkCap: Port #0, Speed 2.5GT/s, Width x1, ASPM L0s L1, Latency L0 <4us, L1 <64us > ClockPM+ Surprise- LLActRep+ BwNot- > LnkCtl: ASPM Disabled; RCB 64 bytes Disabled- Retrain- CommClk+ > ExtSynch- ClockPM- AutWidDis- BWInt- AutBWInt- > LnkSta: Speed 2.5GT/s, Width x1, TrErr- Train- SlotClk+ DLActive+ BWMgmt- ABWMgmt- > > It's at least not listed under http://linuxwireless.org/en/users/Devices/PCI > > If it is supported, which firmware should I use ? (kernel is 3.3-rc2) > It is also supported with b43, but you may need to select Kconfig option for that. Gr. AvS