From: Larry Finger <Larry.Finger@lwfinger.net>
To: Jenya Y <jenya.gerstmaier@live.com>
Cc: linux-wireless <linux-wireless@vger.kernel.org>
Subject: Re: PROBLEM: linux kernel 3.9 rc1 and rtl8187 wireless, unable to connect to any available hotspots.
Date: Thu, 07 Mar 2013 18:54:32 -0600 [thread overview]
Message-ID: <513936C8.5060908@lwfinger.net> (raw)
In-Reply-To: <BLU0-SMTP18556F96AB7DC8FE9D76DA3F1E50@phx.gbl>
On 03/06/2013 11:16 PM, Jenya Y wrote:
> Larry, thank you for reply.
>
> I set up my router with WPA2 // the USB ID Device 008: ID 0bda:8187 Realtek
> Semiconductor Corp. RTL8187 Wireless Adapter.
> (I used lsusb in my 3.8.2, I hope it makes no difference, it's the vendor device
> id I suppose...)
*Never* drop the Cc to any mailing list unless you are prepared to pay for
private consulting!!
I generated a 64-bit version of Linus's current mainline tree. The results for
carious commands are as follows:
finger@linux-cqp5:~/linux-2.6> sudo iwlist wlan1 scan
wlan1 Scan completed :
Cell 01 - Address: C0:3F:0E:BE:2B:44
Channel:3
Frequency:2.422 GHz (Channel 3)
Quality=70/70 Signal level=-36 dBm
Encryption key:on
ESSID:"lwfdjf-n"
Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 11 Mb/s; 18 Mb/s
24 Mb/s; 36 Mb/s; 54 Mb/s
Bit Rates:6 Mb/s; 9 Mb/s; 12 Mb/s; 48 Mb/s
Mode:Master
Extra:tsf=0000027606801313
Extra: Last beacon: 4ms ago
IE: Unknown: 00086C7766646A662D6E
IE: Unknown: 010882848B962430486C
IE: Unknown: 030103
IE: Unknown: 2A0100
IE: Unknown: 2F0100
IE: IEEE 802.11i/WPA2 Version 1
Group Cipher : CCMP
Pairwise Ciphers (1) : CCMP
Authentication Suites (1) : PSK
IE: Unknown: 32040C121860
IE: Unknown:
2D1A1E181AFFFF000001000000000000000000000000000000000000
IE: Unknown: 3D1603051300000000000000000000000000000000000000
IE: Unknown:
DD790050F204104A00011010440001021041000100103B000103104700103452030A44DB81A930CE71790556FE821021000D4E4554474541522C20496E632E10230008574E44523333303010240008574E4452333330301042000230311054000800060050F204000110110008574E445233333030100800020084
IE: Unknown: DD090010180201F0050000
IE: Unknown:
DD180050F2020101800003A4000027A4000042435E0062322F00
IE: Unknown:
DD1E00904C331E181AFFFF000001000000000000000000000000000000000000
IE: Unknown:
DD1A00904C3403051300000000000000000000000000000000000000
finger@linux-cqp5:~/linux-2.6> iwconfig wlan1
wlan1 IEEE 802.11bg ESSID:"lwfdjf-n"
Mode:Managed Frequency:2.422 GHz Access Point: C0:3F:0E:BE:2B:44
Bit Rate=48 Mb/s Tx-Power=20 dBm
Retry long limit:7 RTS thr:off Fragment thr:off
Power Management:off
Link Quality=70/70 Signal level=-39 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:49 Missed beacon:0
finger@linux-cqp5:~/linux-2.6> ifconfig wlan1
wlan1 Link encap:Ethernet HWaddr 00:1B:2F:A2:07:CA
inet addr:192.168.1.115 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::21b:2fff:fea2:7ca/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:18 errors:0 dropped:0 overruns:0 frame:0
TX packets:44 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:6137 (5.9 Kb) TX bytes:11066 (10.8 Kb)
finger@linux-cqp5:~/linux-2.6> uname -r
3.9.0-rc1-Linus+
finger@linux-cqp5:~/linux-2.6> lsusb
Bus 002 Device 002: ID 0409:005a NEC Corp. HighSpeed Hub
Bus 001 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 002 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 002 Device 004: ID 0846:6a00 NetGear, Inc. WG111v2 54 Mbps Wireless [RealTek
RTL8187L]
As you can see, my system connected to a WPA2-encrypted network running 3.9-rc1
from the mainline tree. I do not know what problem you are having, but I cannot
reproduce it. My USB ID is different, but the chip is the same.
Larry
next prev parent reply other threads:[~2013-03-08 0:54 UTC|newest]
Thread overview: 8+ messages / expand[flat|nested] mbox.gz Atom feed top
[not found] <51380336.6030007@live.com>
2013-03-07 3:14 ` PROBLEM: linux kernel 3.9 rc1 and rtl8187 wireless, unable to connect to any available hotspots Jenya Y
2013-03-07 3:59 ` Larry Finger
[not found] ` <BLU0-SMTP18556F96AB7DC8FE9D76DA3F1E50@phx.gbl>
2013-03-08 0:54 ` Larry Finger [this message]
[not found] ` <513A04BD.3020002@gmail.com>
[not found] ` <513A0D9D.8020600@lwfinger.net>
[not found] ` <513A1F5F.3080209@gmail.com>
[not found] ` <513A2824.30603@lwfinger.net>
[not found] ` <513A4154.3040000@gmail.com>
2013-03-08 21:02 ` Larry Finger
2013-03-08 21:23 ` Jenya Y
2013-03-09 1:35 ` Larry Finger
2013-03-09 2:11 ` Jenya Y
2013-03-07 3:24 Jenya Y
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=513936C8.5060908@lwfinger.net \
--to=larry.finger@lwfinger.net \
--cc=jenya.gerstmaier@live.com \
--cc=linux-wireless@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).