Re: Firmware problems with Lesswire Wibear 11n module using mwifiex

[Martin Fuzzey <mfuzzey@parkeon.com>]

Hi Bing,

Thanks for your reply.
On 29/03/13 22:32, Bing Zhao wrote:
> Hi Martin,
>
>> [ 2210.066680] mwifiex_sdio mmc1:0001:1: WLAN FW is active
>> [ 2220.083880] mwifiex_sdio mmc1:0001:1: mwifiex_cmd_timeout_func:
>> Timeout cmd id (1584563353.27844) = 0xa9, act = 0x0
>>
>> This shows that there is no reply to the first command sent in
>> mwifiex_sta_init_cmd()
> There is a possibility that the firmware has responded to this command but the SDIO interrupt gets stuck somewhere.
>
> Are you able to hook up an oscilloscope to check whether SDIO DAT1 pin stays low or not?
Indeed,

DAT1 goes low after the command is sent and stays low until the card is 
reset.

No SDIO interrupts are received by the host controller (i.MX53)

So it looks like a host controller issue - right?

Regards,

Martin