Re: Anyone tried ath10k AP with 40Mhz operation?

[Ben Greear <greearb@candelatech.com>]

On 06/10/2015 11:54 PM, Michal Kazior wrote:
> On 10 June 2015 at 22:31, Ben Greear <greearb@candelatech.com> wrote:
>> I'm trying this hostapd config file.  Beacons seem OK, and station
>> associates.  Station puts DHCP Discover on the air (using 20Mhz according
>> to wireshark).  AP reads this, and thinks it is sending a DHCP response back,
>> but sniffer never shows DHCP response on the air.
>
> Is the MSDU carrying DHCP resp completed with "ok" status? Or is it
> maybe no-ack or discarded?

I'll check, and also try stock firmware to see if that makes a difference.

>> Kernel is 4.0.4+, ath10k firmware is CT firmware, 10.1.467 based.
>>
>> I am curious if anyone else has tried to do this?
>>
>> Thanks,
>> Ben
>>
>> interface=vap50
>> driver=nl80211
>> logger_syslog=-1
>> logger_syslog_level=2
>> logger_stdout=-1
>> logger_stdout_level=2
>> ctrl_interface=/var/run/hostapd
>> ctrl_interface_group=0
>> ssid=ben-ota-2a
> [...]
>
> Works for me on c7b39fdeb479a7956a3c41638d527196ce295fdd
> (github.com/kvalo/ath) with
>   AP: qca988x hw2.0, 10.1.467.2-1
>   STA: qca6174 hw2.2 (its a 2x2),

What NIC model is your qca6174?  In case I cannot
get my setup to work, it would be nice to be able to be able to duplicate
your configuration...


Thanks,
Ben

-- 
Ben Greear <greearb@candelatech.com>
Candela Technologies Inc  http://www.candelatech.com