Re: [PATCH v2] ath10k: enable VHT for IBSS

[Ben Greear <greearb@candelatech.com>]

On 06/10/2015 11:33 PM, Janusz Dziedzic wrote:
> 2015-06-11 8:32 GMT+02:00 Sangwoo Moon <swmoon@lanada.kaist.ac.kr>:
>> Hello,
>>
>> I have successfully installed the latest version of ath10k driver from
>> backports.
>>
>> However, I have some difficulties on configuring wpa_supplicant for IBSS VHT
>> mode.
>> Looked at wpa_supplicant configuration file, but I couldn't found any option
>> related to explicit setting VHT (though I've found disable_vht instead)
>>
>> Sorry for annoying questions, but can you help this out?
>> At least you could let me know your configuration of wpa_supplicant.
>>
> supplicant by default setup wildest BW, no special parameter required
> for IBSS VHT
>
> network = {
>      ssid="ibss"
>      mode=1
>      key_mgmt=NONE
>      frequency=5180
> }
>
> Just use latest version of wpa_supplicant.
> next check you have 80MHz BW
> iw wlan0 info

Make sure you compile supplicant with this option enabled:

CONFIG_IBSS_RSN=y

I think only particular firmware versions are doing to do IBSS as well.

Thanks,
Ben


-- 
Ben Greear <greearb@candelatech.com>
Candela Technologies Inc  http://www.candelatech.com