From mboxrd@z Thu Jan 1 00:00:00 1970 Return-path: Received: from sabertooth02.qualcomm.com ([65.197.215.38]:61864 "EHLO sabertooth02.qualcomm.com" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1753537AbbHFHoL (ORCPT ); Thu, 6 Aug 2015 03:44:11 -0400 Message-ID: <55C31039.6030201@qti.qualcomm.com> (sfid-20150806_094415_049219_2FD5699A) Date: Thu, 6 Aug 2015 13:13:53 +0530 From: Vasanthakumar Thiagarajan MIME-Version: 1.0 To: Felix Fietkau , CC: , Kalle Valo Subject: Re: [PATCH] ath10k: Add QCA99X0 to supported device list References: <1437478567-11339-1-git-send-email-vthiagar@qti.qualcomm.com> <55C1FFBC.7070905@openwrt.org> In-Reply-To: <55C1FFBC.7070905@openwrt.org> Content-Type: text/plain; charset="windows-1252"; format=flowed Sender: linux-wireless-owner@vger.kernel.org List-ID: On Wednesday 05 August 2015 05:51 PM, Felix Fietkau wrote: > On 2015-07-21 13:36, Vasanthakumar Thiagarajan wrote: >> Add vendor/device id of QCA99X0 V2.0 to pci id table and >> QCA99X0_HW_2_0_CHIP_ID_REV to ath10k_pci_supp_chips[] for >> QCA99X0 to get detected by the driver. >> >> Signed-off-by: Vasanthakumar Thiagarajan > I just tested a 99X0 card, and I'm getting this: > > [ 8.742514] ath10k_pci 0000:01:00.0: enabling device (0140 -> 0142) > [ 8.747173] ath10k_pci 0000:01:00.0: pci irq msi interrupts 1 irq_mode 0 reset_mode 0 > [ 11.793314] ath10k_pci 0000:01:00.0: failed to receive initialized event from target: 00000000 > [ 11.793344] ath10k_pci 0000:01:00.0: failed to wait for target after cold reset: -110 > [ 11.800814] ath10k_pci 0000:01:00.0: failed to reset chip: -110 > [ 11.809228] ath10k_pci: probe of 0000:01:00.0 failed with error -110 > > This is on an AP148 board with Linux 3.18, backports generated from > latest wireless-testing (2015-08-03) + all patches from kvalo's ath > tree. Any idea about the version of AP148 that you are using?. By any chance did you check if QCA988X is working on the same board?. Vasanth