Re: [PATCH v2 1/3] wlcore/wl12xx: spi: add power operation function

[Grygorii Strashko <grygorii.strashko@ti.com>]

On 12/24/2015 05:35 PM, Uri Mashiach wrote:
> The power function uses a consumer regulator access to update the WiFi
> enable GPIO value.
>
> Signed-off-by: Uri Mashiach <uri.mashiach@compulab.co.il>
> ---
> v1 -> v2: oops fix was removed to a separate fix.
>
>   drivers/net/wireless/ti/wlcore/spi.c | 37 ++++++++++++++++++++++++++++++++++++
>   1 file changed, 37 insertions(+)
>
> diff --git a/drivers/net/wireless/ti/wlcore/spi.c b/drivers/net/wireless/ti/wlcore/spi.c
>

[...]

> +
>   static struct wl1271_if_operations spi_ops = {
>   	.read		= wl12xx_spi_raw_read,
>   	.write		= wl12xx_spi_raw_write,
>   	.reset		= wl12xx_spi_reset,
>   	.init		= wl12xx_spi_init,
> +	.power		= wl12xx_spi_set_power,
>   	.set_block_size = NULL,
>   };
>
> @@ -353,6 +384,12 @@ static int wl1271_probe(struct spi_device *spi)
>   	 * comes from the board-peripherals file */
>   	spi->bits_per_word = 32;
>
> +	glue->reg = devm_regulator_get(&spi->dev, "vwlan");
> +	if (IS_ERR(glue->reg)) {

It will be more correct to handle -EPROBE_DEFER here also. Like:
  		if (PTR_ERR(glue->reg) == -EPROBE_DEFER)
			return PTR_ERR(glue->reg);

> +		dev_err(glue->dev, "can't get regulator\n");
> +		return PTR_ERR(glue->reg);
> +	}
> +
>   	ret = spi_setup(spi);
>   	if (ret < 0) {
>   		dev_err(glue->dev, "spi_setup failed\n");
>


-- 
regards,
-grygorii