* Re: Driver crashes on resume after suspend
[not found] <CAA05WiZDz1yqHHA-x8bkLSBru_kmwU9wws7gp5NQQEjYEDCaVw@mail.gmail.com>
@ 2018-04-17 8:28 ` Arend van Spriel
0 siblings, 0 replies; only message in thread
From: Arend van Spriel @ 2018-04-17 8:28 UTC (permalink / raw)
To: Carl-Erik Kopseng, brcm80211-dev-list.pdl; +Cc: linux-wireless
+ linux-wireless
On 4/17/2018 12:02 AM, Carl-Erik Kopseng wrote:
> I have a BCM4350 on my Ubuntu 18.04 system. Until today, I could never
> suspend my computer, as the driver brcmfmac would crash on resume
> (looking in dmesg) and only a reboot would make the device reappear.
>
> Today, I found a workaround by making the pm-* commands remove and add
> the module before any power management action:
> echo 'SUSPEND_MODULES="brcmfmac"' | sudo tee -a /etc/pm/config.d/config
>
> This worked fine, but it took me quite a lot of digging, including
> trying out the `wl` driver, the `b43` package, and lots of tweaking. But
> even after going full circle and finding a fix, this still doesn't
> address the actual underlying problem: that brcmfmac doesn't survive
> hibernation and standby. Is there any data I can supply to remedy the
> situation? I attached the dump from wifi debugging utility to pinpoint
> my configuration, but it doesn't contain any dmesg output from the
> kernel crashes. You would probably want a more detailed output than what
> is supplied by dmesg anyway ...
Well. dmesg is always a start so let's have it. If you can compile the
driver you could build it with CONFIG_BRCMDBG enabled and load the
driver with parameter 'debug=0x80000'.
Regards,
Arend
^ permalink raw reply [flat|nested] only message in thread