Re: [PATCH v2] ath: use PRI value given by spec for fixed PRI

[Kalle Valo <kvalo@qca.qualcomm.com>]

Peter Oh <poh@qca.qualcomm.com> writes:

> PRI value is used as divider when DFS detector analyzes candidate
> radar pulses.
> If PRI deviation is big from its origin PRI, DFS detector could miss
> valid radar reports since HW often misses detecting radar pulses and
> causes long interval value of pulses.
>
> For instance from practical results, if runtime PRI is calculated as
> 1431 for fixed PRI value of 1428 and delta timestamp logs 15719,
> the modular remainder will be 1409 and the delta between the remainder
> and runtime PRI is 22 that is bigger than PRI tolerance which is 16.
> As a result this radar report will be ignored even though it's valid.
>
> By using spec defined PRI for fixed PRI, we can correct this error.
>
> Signed-off-by: Peter Oh <poh@qca.qualcomm.com>

Thanks, applied.

-- 
Kalle Valo