Re: [ 57/72] genirq: Unmask oneshot irqs when thread was not woken

[Sven Joachim <svenjoac@gmx.de>]

On 2012-03-04 22:53 +0100, Jonathan Nieder wrote:

> Sven Joachim wrote:
>
>> The laptop is an Acer TravelMate 2490 with a Broadcom chip:
>>
>> ,----
>> | 06:02.0 Network controller: Broadcom Corporation BCM4318 [AirForce One 54g] 802.11g Wireless LAN Controller (rev 02)
>> | 	Subsystem: AMBIT Microsystem Corp. TravelMate 2410
>> | 	Flags: bus master, fast devsel, latency 64, IRQ 10
>> | 	Memory at d0002000 (32-bit, non-prefetchable) [size=8K]
>> | 	Kernel driver in use: b43-pci-bridge
>> `----
>
> Odd.  Does it use that driver with both working and non-working
> kernels?

Yes, although lsmod just tells me that "b43" is loaded.  And
"dmesg | grep b43" shows this:

,----
| [    0.628622] b43-pci-bridge 0000:06:02.0: enabling device (0000 -> 0002)
| [    0.628780] b43-pci-bridge 0000:06:02.0: PCI INT A -> Link[LNKG] -> GSI 10 (level, low) -> IRQ 10
| [    0.628795] b43-pci-bridge 0000:06:02.0: setting latency timer to 64
| [    5.648519] b43-phy0: Broadcom 4318 WLAN found (core revision 9)
| [   36.267694] b43-phy0: Loading firmware version 410.2160 (2007-05-26 15:32:10)
`----

The kernel configuration has these b43 related parameters:

CONFIG_B43=m
CONFIG_B43_SSB=y
CONFIG_B43_PCI_AUTOSELECT=y
CONFIG_B43_PCICORE_AUTOSELECT=y
# CONFIG_B43_PCMCIA is not set
# CONFIG_B43_SDIO is not set
CONFIG_B43_PIO=y
# CONFIG_B43_PHY_N is not set
CONFIG_B43_PHY_LP=y
# CONFIG_B43_PHY_HT is not set
CONFIG_B43_HWRNG=y
# CONFIG_B43_DEBUG is not set
# CONFIG_B43LEGACY is not set
CONFIG_SSB_B43_PCI_BRIDGE=y


Cheers,
       Sven