messages from 2015-09-01 05:32:52 to 2015-09-08 15:56:44 UTC [more...]
[PATCH 01/30] staging: wilc1000: rename WILC_WFI_CfgSetChannel
2015-09-08 15:55 UTC (13+ messages)
` [PATCH 02/30] staging: wilc1000: rename WILC_WFI_CfgScan
` [PATCH 03/30] staging: wilc1000: rename WILC_WFI_CfgConnect
` [PATCH 04/30] staging: wilc1000: rename WILC_WFI_add_key
` [PATCH 05/30] staging: wilc1000: rename WILC_WFI_del_key
` [PATCH 06/30] staging: wilc1000: rename WILC_WFI_get_key
` [PATCH 07/30] staging: wilc1000: rename WILC_WFI_set_default_key
` [PATCH 08/30] staging: wilc1000: rename WILC_WFI_add_virt_intf
` [PATCH 09/30] staging: wilc1000: rename WILC_WFI_del_virt_intf
` [PATCH 10/30] staging: wilc1000: rename WILC_WFI_change_virt_intf
` [PATCH 11/30] staging: wilc1000: rename WILC_WFI_start_ap
` [PATCH 12/30] staging: wilc1000: rename WILC_WFI_change_beacon
` [PATCH 13/30] staging: wilc1000: rename WILC_WFI_stop_ap
[PATCH] wireless-regdb: add 2.4GHz regulatory rules for Cuba (CU)
2015-09-08 14:22 UTC (4+ messages)
bcmdhd: Concurrent use of wlan0 and virtual interface in managed mode
2015-09-08 9:24 UTC (7+ messages)
` Fwd: "
Using ath5k/ath9k radio for constant-tx noise source
2015-09-08 9:21 UTC (2+ messages)
QCA6174 hw2.1 irq_mode=0 broken on 4.2-rc3, working on 4.1.2
2015-09-08 8:17 UTC (13+ messages)
[PATCH 1/5] staging: wilc1000: define undefined operation mode
2015-09-08 8:08 UTC (5+ messages)
` [PATCH 2/5] staging: wilc1000: remove meaningless line
` [PATCH 3/5] staging: wilc1000: add maintainers for Atmel 802.11 driver
` [PATCH 4/5] staging: wilc1000: remove unused NM73131_0_BOARD
` [PATCH 5/5] staging: wilc1000: delete definition USE_WIRELESS
iwlwifi: FW error in SYNC CMD MAC_CONTEXT_CMD
2015-09-08 6:31 UTC (3+ messages)
[PATCH 1/5] staging: wilc1000: linux_wlan.c: use kzalloc instead of WILC_MALLOC
2015-09-08 4:48 UTC (7+ messages)
` [PATCH 2/5] staging: wilc1000: linux_wlan.c: add kzalloc error check
` [PATCH 3/5] staging: wilc1000: remove commented codes
` [PATCH 4/5] staging: wilc1000: wilc_msgqueue.c: use kmalloc with GFP_ATOMIC
` [PATCH 5/5] staging: wilc1000: host_interface.c: fix build warning
[PATCH v6] Add new mac80211 driver mwlwifi
2015-09-08 1:28 UTC (5+ messages)
[question] panic when calling drv_get_tsf
2015-09-08 1:20 UTC (2+ messages)
[PATCH v2 0/1] rtl8xxxu (mac80211) driver for rtl8188[cr]u/rtl8192cu/rtl8723au
2015-09-07 21:08 UTC (16+ messages)
` [PATCH 1/1] New driver: rtl8xxxu (mac80211)
[PATCH] rtlwifi: rtl818x: Move drivers into new realtek directory
2015-09-07 20:59 UTC
[PATCH v3 0/1] New driver: rtl8723au (mac80211)
2015-09-07 18:50 UTC (9+ messages)
` [PATCH 1/1] "
using dev_coredumpv
2015-09-07 16:35 UTC (3+ messages)
[PATCH] ath6kl: remove redundant null pointer check on send_pkt
2015-09-07 13:49 UTC
[PATCH v5] Add new mac80211 driver mwlwifi
2015-09-07 11:20 UTC (9+ messages)
[PATCH v3] Add new mac80211 driver mwlwifi
2015-09-07 11:09 UTC (4+ messages)
[PATCH 1/3] staging: wilc1000: remove dead codes
2015-09-07 10:09 UTC (3+ messages)
` [PATCH 2/3] staging: wilc1000: remove unused preprocessor definition
` [PATCH 3/3] staging: wilc1000: fix potential memory leak
pull-request: mac80211 2015-09-04
2015-09-07 2:50 UTC (2+ messages)
[PATCH] Add new mac80211 driver mwlwifi
2015-09-06 17:09 UTC (8+ messages)
[PATCH v2] ath9k_htc: introduce support for different fw versions
2015-09-06 13:16 UTC (5+ messages)
` [PATCH v3] "
[PATCHv3] staging: wilc1000: replace MALLOC_WILC_BUFFER() macro to avoid possible memory leak
2015-09-05 16:29 UTC (6+ messages)
` [PATCHv4 0/2] staging: wilc1000: code improvements
` [PATCHv4 1/2] staging: wilc1000: remove FREE_WILC_BUFFER()
[PATCH 0/1] rtl8xxxu (mac80211) driver for rtl8188[cr]u/rtl8192cu/rtl8723au
2015-09-05 4:02 UTC (14+ messages)
` [PATCH 1/1] New driver: rtl8xxxu (mac80211)
[PATCH] cfg80211: handle fragmented IEs in splitting
2015-09-04 18:03 UTC
[PATCH 0/5] staging: wilc1000: support 64bit machine and remove warnings
2015-09-04 16:24 UTC (6+ messages)
` [PATCH 3/5] staging: wilc1000: use id value as argument
[RFC] Monitor interface for rtl8188eu
2015-09-04 16:17 UTC (2+ messages)
` [RFC] staging: rtl8188eu: Introduce monitor interface for IEEE 802.11 frames
kernel log flooded with GET_CMD_NODE: cmd node not available
2015-09-04 13:00 UTC (6+ messages)
[PATCH] ath: use PRI value given by spec for fixed PRI
2015-09-04 12:55 UTC (7+ messages)
[PATCH 0/9] various patches from our internal tree
2015-09-04 12:32 UTC (3+ messages)
` [PATCH 8/9] mac80211: avoid VHT usage with no 80MHz chans allowed
[PATCH] cfg80211: regulatory: restore proper user alpha2
2015-09-04 12:30 UTC (2+ messages)
[PATCH] rfkill: Copy "all" global state to other types
2015-09-04 12:28 UTC (8+ messages)
[PATCH] mac80211: protect non-HT BSS when HT TDLS traffic exists
2015-09-04 12:26 UTC (2+ messages)
[PATCH] mac80211: Do not use sizeof() on pointer type
2015-09-04 12:24 UTC (2+ messages)
[PATCH] staging: wilc1000: fix freeing of ERR_PTR
2015-09-04 10:04 UTC
FCC's new regulations on 5Ghz Wifi
2015-09-04 7:13 UTC (3+ messages)
[PATCH] mac80211: fix the setting of center freq segment 2 in VHT oper ie
2015-09-04 5:52 UTC (2+ messages)
Linux Firmware Signing
2015-09-03 21:14 UTC (36+ messages)
[PATCH v2] staging/wilc1000: Use %pM format specifier to print mac address
2015-09-03 18:48 UTC (5+ messages)
fcc hardware lockdown
2015-09-03 14:59 UTC
[PATCH 1/2] ath10k: split switch_vif_chanctx guts
2015-09-03 8:44 UTC (2+ messages)
` [PATCH 2/2] ath10k: handle IEEE80211_CHANCTX_CHANGE_WIDTH properly
[PATCH] ath10k: move hw_scan worker queuing
2015-09-03 8:43 UTC
iwlwifi lockup problems
2015-09-03 5:45 UTC (2+ messages)
[PATCH 3/3] staging/wilc1000: Use %pM format specifier to print mac address
2015-09-03 1:37 UTC (2+ messages)
[PATCH] net/wireless/wl18xx: Add missing MODULE_FIRMWARE
2015-09-02 23:56 UTC
[PATCH 1/2] ath10k: change beamformee VHT STS capability
2015-09-02 14:45 UTC (5+ messages)
[PATCH] staging: rtl8723au: remove unnecessary le32_to_cpu
2015-09-02 12:55 UTC (2+ messages)
[PATCH 1/2] mac80211: Split sending tx'ed frames to monitor interfaces into its own function
2015-09-02 11:23 UTC (2+ messages)
` [PATCH 2/2] mac80211: Copy tx'ed beacons to monitor mode
[PATCH 1/2] ath10k: fix beamformee VHT STS capability
2015-09-02 11:20 UTC (2+ messages)
` [PATCH 2/2] ath10k: fix beamformer VHT sounding dimensions capability
[PATCH] ath10k: invalid mcs reported in rx descriptor
2015-09-02 6:51 UTC
How to set a scan on a given frequency
2015-09-02 4:48 UTC (3+ messages)
CT firmware beta-15 can now tune noise-floor thresholds
2015-09-01 21:29 UTC
[RFC 0/2] Send own beacons to monitor interfaces
2015-09-01 15:53 UTC (6+ messages)
` [RFC 1/2] mac80211: Split sending tx'ed frames to monitor interfaces into its own function
` [RFC 2/2] mac80211: Copy tx'ed beacons to monitor mode
[PATCH] fixup! wil6210: system power management
2015-09-01 15:47 UTC (2+ messages)
[PATCH] mwifiex: Make mwifiex_dbg a function, reduce object size
2015-09-01 15:16 UTC (3+ messages)
[PATCH v2 0/9] Adds Intel FieldsPeak NFC solution driver
2015-09-01 14:54 UTC (10+ messages)
` [PATCH v2 1/9] nfc: nci: Export nci data send API
` [PATCH v2 2/9] nfc: nci: Add function to get max packet size for conn
` [PATCH v2 3/9] nfc: nci: Introduce new core opcodes
` [PATCH v2 4/9] nfc: nci: Allow the driver to set handler for core nci ops
` [PATCH v2 5/9] nfc: nci: Do not call post_setup when setup fails
` [PATCH v2 6/9] nfc: nci: Introduce nci_core_cmd
` [PATCH v2 7/9] nfc: nci: Use a separate mutex for nci open and close
` [PATCH v2 8/9] nfc: nci: Add a parameter to get the new connection id
` [PATCH v2 9/9] nfc: Add Intel Fields Peak NFC solution driver
RTL8189ETV
2015-09-01 11:27 UTC (8+ messages)
[PATCH iw] iw: display interface TX power if available
2015-09-01 7:55 UTC
[PATCH] nl80211: put current TX power in interface info
2015-09-01 7:48 UTC (2+ messages)
[PATCH] ath10k: Disable PCI power save for QCA99X0
2015-09-01 7:36 UTC (2+ messages)
Ubuntu 14.04 and the intel 3160 chip monitor mode support
2015-09-01 5:32 UTC (5+ messages)
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).