messages from 2026-03-30 02:59:24 to 2026-03-30 11:34:41 UTC [more...]
[BUG] wifi: rtw88: Hard system freeze on RTL8821CE when power_save is enabled (LPS/ASPM conflict)
2026-03-30 11:34 UTC (19+ messages)
[PATCH v3 00/15] firmware: qcom: Add OP-TEE PAS service support
2026-03-30 10:36 UTC (3+ messages)
` [PATCH v3 04/15] firmware: qcom: Add a PAS TEE service
[PATCH 0/3] wifi: refactor USB endpoint lookups
2026-03-30 10:32 UTC (4+ messages)
` [PATCH 1/3] wifi: at76c50x: refactor endpoint lookup
` [PATCH 2/3] wifi: libertas: "
` [PATCH 3/3] wifi: libertas_tf: "
[PATCH ath-next v5] wifi: ath12k: avoid dynamic alloc when parsing wmi tb
2026-03-30 10:24 UTC
[PATCH v5 0/9] arm64: dts: amlogic: Add MMC/SD/SDIO support for Khadas VIM4 (Amlogic T7)
2026-03-30 10:18 UTC (4+ messages)
` [PATCH v5 6/9] arm64: dts: amlogic: t7: khadas-vim4: Add power regulators
[RFC PATCH RESEND 0/3] net: ath11k: Firmware lockup detection & mitigation
2026-03-30 10:05 UTC (4+ messages)
` [PATCH RESEND RFC 1/3] net: ath11k: fix redundant reset from stale pending workqueue bit
` [PATCH RESEND RFC 2/3] net: ath11k: add firmware lockup detection and recovery
` [PATCH RESEND RFC 3/3] net: ath11k: add lockup simulation via debugfs
[PATCH rtw-next] wifi: rtw89: Add support for Elecom WDC-XE2402TU3-B
2026-03-30 9:34 UTC
[PATCH] net: rfkill: prevent unlimited numbers of rfkill events from being created
2026-03-30 9:14 UTC
[PATCH] ath11k: workaround firmware bug where peer_id=0
2026-03-30 7:57 UTC (2+ messages)
[PATCH v2 00/15] firmware: qcom: Add OP-TEE PAS service support
2026-03-30 7:08 UTC (12+ messages)
` [PATCH v2 02/15] firmware: qcom: Add a generic PAS service
[PATCH rtw-next 0/9] wifi: rtw89: 8922d: add RTL8922DE part 2/2
2026-03-30 6:58 UTC (10+ messages)
` [PATCH rtw-next 1/9] wifi: rtw89: 8922d: BB hardware pre-/post-init, TX/RX path and power settings
` [PATCH rtw-next 2/9] wifi: rtw89: 8922d: add set channel with pre-/post- helpers
` [PATCH rtw-next 3/9] wifi: rtw89: 8922d: add RF calibration ops
` [PATCH rtw-next 4/9] wifi: rtw89: 8922d: add set TX power callback
` [PATCH rtw-next 5/9] wifi: rtw89: 8922d: configure TX/RX path assisting in BT coexistence
` [PATCH rtw-next 6/9] wifi: rtw89: 8922d: add RF ops of init hardware and get thermal
` [PATCH rtw-next 7/9] wifi: rtw89: 8922d: add ops related to BT coexistence mechanism
` [PATCH rtw-next 8/9] wifi: rtw89: 8922d: add chip_info and chip_ops struct
` [PATCH rtw-next 9/9] wifi: rtw89: 8922d: add PCI ID of RTL8922DE and RTL8922DE-VS
iwlwifi-mld: Fix fw id leak in OOM case
2026-03-30 6:55 UTC (4+ messages)
[PATCH] wifi: iwlwifi: ptp: Fix potential race condition in PTP removal
2026-03-30 6:49 UTC (4+ messages)
` [PATCH v2 1/2] wifi: iwlwifi: mvm: fix "
[PATCH v3] wifi: rtw89: usb: fix TX flow control by tracking in-flight URBs
2026-03-30 5:35 UTC (3+ messages)
` [PATCH v5] "
[PATCH rtw-next 00/12] wifi: rtw89: Add support for RTL8922AU
2026-03-30 4:30 UTC (25+ messages)
` [PATCH rtw-next 01/12] wifi: rtw89: usb: Disable MLO for now
` [PATCH rtw-next 02/12] wifi: rtw89: usb: Support 2 bulk in endpoints
` [PATCH rtw-next 03/12] wifi: rtw89: Fix rtw89_usb_ops_mac_lv1_rcvy() for RTL8922AU
` [PATCH rtw-next 04/12] wifi: rtw89: Fix rtw89_usb_ops_mac_pre_init() "
` [PATCH rtw-next 05/12] wifi: rtw89: Fix rtw89_usb_ops_mac_post_init() "
` [PATCH rtw-next 06/12] wifi: rtw89: usb: Enable RX aggregation "
` [PATCH rtw-next 07/12] wifi: rtw89: Fix rtw8922a_pwr_{on,off}_func() for USB
` [PATCH rtw-next 08/12] wifi: rtw89: Let hfc_param_ini have separate settings for USB 2/3
` [PATCH rtw-next 09/12] wifi: rtw89: Add rtw8922a_hfc_param_ini_usb{2,3}
` [PATCH rtw-next 10/12] wifi: rtw89: Add rtw8922a_dle_mem_usb{2,3}
` [PATCH rtw-next 11/12] wifi: rtw89: Add rtw8922au.c
` [PATCH rtw-next 12/12] wifi: rtw89: Enable the new rtw89_8922au module
[PATCH ath-next] wifi: ath12k: Skip adding inactive partner vdev info
2026-03-30 4:07 UTC
[PATCH] iwlwifi: dvm: add missing cleaup for on error path
2026-03-30 3:35 UTC (2+ messages)
page: | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox