Linux wireless drivers development
 help / color / mirror / Atom feed
 messages from 2026-07-30 13:26:15 to 2026-07-30 16:22:05 UTC [more...]

[PATCH v2 1/8] wifi: brcmfmac: flowring: replace O(N) loop with atomic counter
 2026-07-30 16:21 UTC  (8+ messages)
` [PATCH v2 2/8] wifi: brcmfmac: sdio: coalesce host locks in rx path
` [PATCH v2 3/8] wifi: brcmfmac: core: populate radiotap header with RSSI
` [PATCH v2 4/8] wifi: brcmfmac: cfg80211: implement PMKID_V2 and fix delay busy-wait
` [PATCH v2 5/8] wifi: brcmfmac: msgbuf: tune thresholds and optimize sleep latency
` [PATCH v2 6/8] wifi: brcmfmac: pcie: optimize latency and irq teardown
` [PATCH v2 7/8] wifi: brcmfmac: fwsignal: safe no-op on duplicate MAC add
` [PATCH v2 8/8] wifi: brcmsmac: ampdu: clarify standard compliance on QoS change

[PATCH] wifi: mac80211: defer AP-side FT key upload until association
 2026-07-30 16:21 UTC  (2+ messages)

[PATCH 1/8] wifi: brcmfmac: flowring: replace O(N) loop with atomic counter
 2026-07-30 16:03 UTC  (8+ messages)
` [PATCH 2/8] wifi: brcmfmac: sdio: coalesce host locks in rx path
` [PATCH 3/8] wifi: brcmfmac: core: populate radiotap header with RSSI
` [PATCH 4/8] wifi: brcmfmac: cfg80211: implement PMKID_V2 and fix delay busy-wait
` [PATCH 5/8] wifi: brcmfmac: msgbuf: tune thresholds and optimize sleep latency
` [PATCH 6/8] wifi: brcmfmac: pcie: optimize latency and irq teardown
` [PATCH 7/8] wifi: brcmfmac: fwsignal: safe no-op on duplicate MAC add
` [PATCH 8/8] wifi: brcmsmac: ampdu: clarify standard compliance on QoS change

[PATCH v9 00/10] Support for block device NVMEM providers
 2026-07-30 16:00 UTC  (11+ messages)
` [PATCH v9 01/10] dt-bindings: mmc: Document fixed-layout NVMEM provider support
` [PATCH v9 02/10] dt-bindings: net: wireless: qcom,ath10k: Document NVMEM cells
` [PATCH v9 03/10] dt-bindings: bluetooth: qcom: Add NVMEM BD address cell
` [PATCH v9 04/10] nvmem: layouts: Support fixed-layout as the nvmem device node itself
` [PATCH v9 05/10] block: partitions: of: Attach partition fwnode to the block device
` [PATCH v9 06/10] block: implement NVMEM provider
` [PATCH v9 07/10] net: of_net: Add of_get_nvmem_eui48() helper for EUI-48 lookup
` [PATCH v9 08/10] Bluetooth: hci_sync: Add NVMEM-backed BD address retrieval
` [PATCH v9 09/10] Bluetooth: qca: Set NVMEM BD address quirks when address is invalid
` [PATCH v9 10/10] arm64: dts: qcom: arduino-imola: Describe NVMEM layout for WiFi/BT addresses

[PATCH mt76] wifi: mt76: mt792x: drop redundant napi_disable() in unregister path
 2026-07-30 15:22 UTC  (4+ messages)

[PATCH ath-next v3] wifi: ath6kl: return 0 explicitly in ath6kl_init_upload()
 2026-07-30 15:10 UTC  (2+ messages)

[PATCH ath-next 0/2] wifi: ath: fix stride mismatch in mac_phy_caps_parse
 2026-07-30 15:10 UTC  (2+ messages)

[PATCH wireless-next 0/8] Adding NO_STA flag and reworking RX link resolution
 2026-07-30 14:34 UTC  (9+ messages)
` [PATCH wireless-next 1/8] wifi: iwlwifi: use link_sta internally to the driver
` [PATCH wireless-next 2/8] wifi: mac80211: change public RX API to use link stations
` [PATCH wireless-next 3/8] wifi: mac80211: refactor RX link_id and station handling
` [PATCH wireless-next 4/8] wifi: mac80211: rework RX packet handling
` [PATCH wireless-next 5/8] wifi: cfg80211: add attribute for TX/RX denoting there is no station
` [PATCH wireless-next 6/8] wifi: mac80211: report to cfg80211 when no STA is known for a frame
` [PATCH wireless-next 7/8] wifi: mac80211: pass station to ieee80211_tx_skb_tid
` [PATCH wireless-next 8/8] wifi: mac80211: pass error station if non-STA transmit was requested

[PATCH v2 01/11] wifi: rtw88: add the RTL8723B chip type and SDIO helper
 2026-07-30 14:28 UTC  (4+ messages)

[PATCH ath-current v2] wifi: ath11k: reset ar->num_station on hardware start
 2026-07-30 14:03 UTC 

[PATCH ath-current v2] wifi: ath11k: cleanup arsta in ath11k_mac_peer_cleanup_all()
 2026-07-30 14:02 UTC 

[PATCH ath-next] wifi: ath12k: fix encrypted EAPOL TX in encap offload mode
 2026-07-30 12:51 UTC  (2+ messages)


This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox