messages from 2026-10-31 07:10:12 to 2026-10-31 17:56:55 UTC [more...]
[PATCH rtw-next v2 0/2] wifi: rtw88: check C2H header and payload lengths
2026-10-31 17:56 UTC (3+ messages)
` [PATCH rtw-next v2 1/2] wifi: rtw88: drop C2H packets shorter than the C2H header
` [PATCH rtw-next v2 2/2] wifi: rtw88: check the C2H payload length before reading it
[PATCH wireless-next 0/8] wifi: rt2x00: improve the throughput of rt2800usb
2026-10-31 17:23 UTC (14+ messages)
` [PATCH wireless-next 1/8] wifi: rt2x00: start the link tuner when an interface is added
` [PATCH wireless-next 2/8] wifi: rt2800: calibrate the crystal of RT3593 with the beacons
` [PATCH wireless-next 4/8] wifi: rt2800: report the MCS16 to MCS8 fallback of RT3593 in TX status
` [PATCH wireless-next 6/8] wifi: rt2800: set the mac80211 fast-xmit and aggregation flags
[PATCH wireless-next v2 0/7] wifi: rt2x00: improve the throughput of rt2800usb
2026-10-31 16:55 UTC (9+ messages)
` [PATCH wireless-next v2 1/7] wifi: rt2x00: start the link tuner when an interface is added
` [PATCH wireless-next v2 2/7] wifi: rt2800: calibrate the crystal of RT3593 with the beacons
` [PATCH wireless-next v2 3/7] wifi: rt2800: make MCS 16 fall back to MCS 8 on devices with 3 TX chains
` [PATCH wireless-next v2 4/7] wifi: rt2800: don't report an A-MPDU length to minstrel_ht
` [PATCH wireless-next v2 5/7] wifi: rt2800: support A-MSDU in A-MPDU
` [PATCH wireless-next v2 6/7] wifi: rt2800usb: enable RX bulk aggregation
` [PATCH wireless-next v2 7/7] wifi: rt2x00usb: use a threaded NAPI with GRO for RX
[PATCH] wifi: mt76: usb: re-enable the rx worker when resuming fails
2026-10-31 16:51 UTC (2+ messages)
` [PATCH v2] "
[PATCH ath-next] wifi: ath11k: don't warn when a country leaves a pdev without channels
2026-10-31 15:30 UTC
[PATCH v3 2/8] KVM: add PCI MSI hypercall for VFIO passthrough
2026-10-31 12:07 UTC (2+ messages)
[PATCH v2 6.6.y] wifi: cfg80211: release locks on error in cfg80211_wext_siwgenie()
2026-10-31 11:27 UTC (2+ messages)
[PATCH wireless-next v3 00/10] bcma-ac-rev1: support 4352/4360 rev3 chips
2026-10-31 9:15 UTC (11+ messages)
` [PATCH wireless-next v3 01/10] bcma: core: clear only FORCEHT for BCMA_CLKMODE_DYNAMIC
` [PATCH wireless-next v3 02/10] bcma: pmu: init PLL and resources on BCM4352/BCM4360
` [PATCH wireless-next v3 03/10] bcma: pcie2: request HT "
` [PATCH wireless-next v3 04/10] bcma: chipcommon: enable asynchronous GPIO interrupts
` [PATCH wireless-next v3 05/10] bcma: extract SPROM revision 11
` [PATCH wireless-next v3 06/10] firmware: bcm47xx_sprom: read the SPROM revision 11 fields from NVRAM
` [PATCH wireless-next v3 07/10] firmware: bcm47xx_sprom: read ledbh4..ledbh15 "
` [PATCH wireless-next v3 08/10] firmware: bcm47xx_sprom: read boardflags3 from NVRAM over the SPROM
` [PATCH wireless-next v3 09/10] bcma: add the single-band BCM4352/BCM4360 PCI IDs
` [PATCH wireless-next v3 10/10] wifi: b43: add the 2.4 GHz BCM4352/BCM4360 to the supported bands
[syzbot] [wireless?] WARNING in rfkill_dev_uevent
2026-10-31 8:52 UTC
[PATCH rtw-next v7 0/4] wifi: rtw88: sdio: Fix unhandled RX request interrupt storm
2026-10-31 8:41 UTC (4+ messages)
` [PATCH rtw-next v7 2/4] wifi: rtw88: sdio: Track running state and cancel TX worker on stop
[PATCH wireless-next] wifi: rt2x00: rt2800lib: fallback to default RF config when EEPROM_NIC_CONF0 is 0x0000
2026-10-31 7:50 UTC (2+ messages)
[PATCH rtw-next 0/5] wifi: rtw88: pci: Support an older design, like RTL8821AE/RTL8812AE
2026-10-31 7:42 UTC (8+ messages)
[PATCH rtw-next v2 0/7] wifi: rtw88: extend 88xxA support
2026-10-31 7:09 UTC (8+ messages)
` [PATCH rtw-next v2 1/7] wifi: rtw88: 8812a, 8814a: enable STBC for HT transmissions
` [PATCH rtw-next v2 2/7] wifi: rtw88: 88xxa: receive VHT SU beamformed transmissions
` [PATCH rtw-next v2 3/7] wifi: rtw88: correctly expose beamformee capabilities
` [PATCH rtw-next v2 4/7] wifi: rtw88: prepare frequency-offset correction for more chips
` [PATCH rtw-next v2 5/7] wifi: rtw88: 88xxa: correct carrier-frequency offset
` [PATCH rtw-next v2 6/7] wifi: rtw88: 88xxa: adapt channel sensing to receiver gain
` [PATCH rtw-next v2 7/7] wifi: rtw88: 8812a, 8821a: respect peer A-MPDU size limits
page: | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox