From: Vincent Donnefort <vdonnefort@google.com>
To: linux-wireless@vger.kernel.org
Cc: luciano.coelho@intel.com
Subject: [Bug] iwlwifi microcode error
Date: Sun, 22 Jan 2023 17:48:50 +0000 [thread overview]
Message-ID: <Y813ApLzGgNMHMBu@google.com> (raw)
Hi all,
Recently, the network card on my laptop (AX201) started to lose the wifi 3 or 4
times a day. When it happens, the only way I have to reconnect is to restart my
network manager.
I found in dmesg the following:
iwlwifi 0000:00:14.3: Microcode SW error detected. Restarting 0x0.
iwlwifi 0000:00:14.3: Start IWL Error Log Dump:
iwlwifi 0000:00:14.3: Transport status: 0x0000004A, valid: 6
iwlwifi 0000:00:14.3: Loaded firmware version: 71.058653f6.0 QuZ-a0-hr-b0-71.ucode
iwlwifi 0000:00:14.3: 0x00000071 | NMI_INTERRUPT_UMAC_FATAL
iwlwifi 0000:00:14.3: 0x0000A200 | trm_hw_status0
iwlwifi 0000:00:14.3: 0x00000000 | trm_hw_status1
iwlwifi 0000:00:14.3: 0x004CBE06 | branchlink2
iwlwifi 0000:00:14.3: 0x0001AB16 | interruptlink1
iwlwifi 0000:00:14.3: 0x0001AB16 | interruptlink2
iwlwifi 0000:00:14.3: 0x004C3E98 | data1
iwlwifi 0000:00:14.3: 0x00001000 | data2
iwlwifi 0000:00:14.3: 0x00000000 | data3
iwlwifi 0000:00:14.3: 0x96800FF7 | beacon time
iwlwifi 0000:00:14.3: 0x424B6011 | tsf low
iwlwifi 0000:00:14.3: 0x000001FB | tsf hi
iwlwifi 0000:00:14.3: 0x00000000 | time gp1
iwlwifi 0000:00:14.3: 0xACE77E1C | time gp2
iwlwifi 0000:00:14.3: 0x00000001 | uCode revision type
iwlwifi 0000:00:14.3: 0x00000047 | uCode version major
iwlwifi 0000:00:14.3: 0x058653F6 | uCode version minor
iwlwifi 0000:00:14.3: 0x00000351 | hw version
iwlwifi 0000:00:14.3: 0x00489001 | board version
iwlwifi 0000:00:14.3: 0x8008FC03 | hcmd
iwlwifi 0000:00:14.3: 0x24020000 | isr0
iwlwifi 0000:00:14.3: 0x01000000 | isr1
iwlwifi 0000:00:14.3: 0x08F04002 | isr2
iwlwifi 0000:00:14.3: 0x04C3200C | isr3
iwlwifi 0000:00:14.3: 0x00000000 | isr4
iwlwifi 0000:00:14.3: 0x04B1001C | last cmd Id
iwlwifi 0000:00:14.3: 0x004C3E98 | wait_event
iwlwifi 0000:00:14.3: 0x000002C8 | l2p_control
iwlwifi 0000:00:14.3: 0x00018014 | l2p_duration
iwlwifi 0000:00:14.3: 0x000000BF | l2p_mhvalid
iwlwifi 0000:00:14.3: 0x000000EF | l2p_addr_match
iwlwifi 0000:00:14.3: 0x00000008 | lmpm_pmg_sel
iwlwifi 0000:00:14.3: 0x00000000 | timestamp
iwlwifi 0000:00:14.3: 0x0000D0A0 | flow_handler
iwlwifi 0000:00:14.3: Start IWL Error Log Dump:
iwlwifi 0000:00:14.3: Transport status: 0x0000004A, valid: 7
iwlwifi 0000:00:14.3: 0x20003463 | ADVANCED_SYSASSERT
iwlwifi 0000:00:14.3: 0x00000000 | umac branchlink1
iwlwifi 0000:00:14.3: 0x80455B7C | umac branchlink2
iwlwifi 0000:00:14.3: 0xC0081200 | umac interruptlink1
iwlwifi 0000:00:14.3: 0x00000000 | umac interruptlink2
iwlwifi 0000:00:14.3: 0x424B6003 | umac data1
iwlwifi 0000:00:14.3: 0xACE77E0D | umac data2
iwlwifi 0000:00:14.3: 0x96653FD6 | umac data3
iwlwifi 0000:00:14.3: 0x00000047 | umac major
iwlwifi 0000:00:14.3: 0x058653F6 | umac minor
iwlwifi 0000:00:14.3: 0xACE77E16 | frame pointer
iwlwifi 0000:00:14.3: 0xC0885E00 | stack pointer
iwlwifi 0000:00:14.3: 0x0023010C | last host cmd
iwlwifi 0000:00:14.3: 0x00000000 | isr status reg
iwlwifi 0000:00:14.3: IML/ROM dump:
iwlwifi 0000:00:14.3: 0x00000003 | IML/ROM error/state
iwlwifi 0000:00:14.3: 0x00005710 | IML/ROM data1
iwlwifi 0000:00:14.3: 0x00000080 | IML/ROM WFPM_AUTH_KEY_0
iwlwifi 0000:00:14.3: Fseq Registers:
iwlwifi 0000:00:14.3: 0x60000000 | FSEQ_ERROR_CODE
iwlwifi 0000:00:14.3: 0x80290033 | FSEQ_TOP_INIT_VERSION
iwlwifi 0000:00:14.3: 0x00090006 | FSEQ_CNVIO_INIT_VERSION
iwlwifi 0000:00:14.3: 0x0000A482 | FSEQ_OTP_VERSION
iwlwifi 0000:00:14.3: 0x00000003 | FSEQ_TOP_CONTENT_VERSION
iwlwifi 0000:00:14.3: 0x4552414E | FSEQ_ALIVE_TOKEN
iwlwifi 0000:00:14.3: 0x20000302 | FSEQ_CNVI_ID
iwlwifi 0000:00:14.3: 0x01300504 | FSEQ_CNVR_ID
iwlwifi 0000:00:14.3: 0x20000302 | CNVI_AUX_MISC_CHIP
iwlwifi 0000:00:14.3: 0x01300504 | CNVR_AUX_MISC_CHIP
iwlwifi 0000:00:14.3: 0x05B0905B | CNVR_SCU_SD_REGS_SD_REG_DIG_DCDC_VTRIM
iwlwifi 0000:00:14.3: 0x0000025B | CNVR_SCU_SD_REGS_SD_REG_ACTIVE_VDIG_MIRROR
iwlwifi 0000:00:14.3: WRT: Collecting data: ini trigger 4 fired (delay=0ms).
ieee80211 phy0: Hardware restart was requested
This seems to only happen when I'm connected to a 802.11e capable router and
after my firmware has been upgraded from 20210818-1 to 20221012-1.
Is that a known issue?
--
Vincent
next reply other threads:[~2023-01-22 17:48 UTC|newest]
Thread overview: 2+ messages / expand[flat|nested] mbox.gz Atom feed top
2023-01-22 17:48 Vincent Donnefort [this message]
2023-01-22 19:04 ` [Bug] iwlwifi microcode error Greenman, Gregory
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=Y813ApLzGgNMHMBu@google.com \
--to=vdonnefort@google.com \
--cc=linux-wireless@vger.kernel.org \
--cc=luciano.coelho@intel.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox