From: Sascha Hauer <s.hauer@pengutronix.de>
To: Francesco Dolcini <francesco@dolcini.it>
Cc: David Lin <yu-hao.lin@nxp.com>,
linux-wireless@vger.kernel.org, linux-kernel@vger.kernel.org,
kvalo@kernel.org, johannes@sipsolutions.net,
briannorris@chromium.org, tsung-hsien.hsieh@nxp.com,
kernel@pengutronix.de
Subject: Re: [PATCH v2 00/43] wifi: nxpwifi: create nxpwifi to support iw61x
Date: Mon, 26 Aug 2024 09:43:01 +0200 [thread overview]
Message-ID: <ZswyBSyDC8it95Zt@pengutronix.de> (raw)
In-Reply-To: <20240824134839.GA21315@francesco-nb>
On Sat, Aug 24, 2024 at 03:48:39PM +0200, Francesco Dolcini wrote:
> On Thu, Aug 22, 2024 at 02:56:25PM +0200, Sascha Hauer wrote:
> > On Fri, Aug 09, 2024 at 05:44:50PM +0800, David Lin wrote:
> > > This series adds support for IW61x which is a new family of 2.4/5 GHz
> > > dual-band 1x1 Wi-Fi 6, Bluetooth/Bluetooth Low Energy 5.2 and 15.4
> > > tri-radio single chip by NXP. These devices support 20/40/80MHz
> > > single spatial stream in both STA and AP mode. Communication to the
> > > IW61x is done via SDIO interface
> > >
> > > This driver is a derivative of existing Mwifiex [1] and based on similar
> > > full-MAC architecture [2]. It has been tested with i.MX8M Mini evaluation
> > > kits in both AP and STA mode.
> > >
> > > All code passes sparse and checkpatch
> > >
> > > Data sheet (require registration):
> > > https://www.nxp.com/products/wireless-connectivity/wi-fi-plus-bluetooth-
> > > plus-802-15-4/2-4-5-ghz-dual-band-1x1-wi-fi-6-802-11ax-plus-bluetooth-5-
> > > 4-plus-802-15-4-tri-radio-solution:IW612
> > >
> > > Known gaps to be addressed in the following patches,
> > > - Enable 11ax capabilities. This initial patch support up to 11ac.
> > > - Support DFS channel. This initial patch doesn't support DFS channel in
> > > both AP/STA mode.
> > >
> > > This patch is presented as a request for comment with the intention of being
> > > made into a patch after initial feedbacks are addressed
> > >
> > > [1] We had considered adding IW61x to mwifiex driver, however due to
> > > FW architecture, host command interface and supported features are
> > > significantly different, we have to create the new nxpwifi driver.
> > > Subsequent NXP chipsets will be added and sustained in this new driver.
> >
> > I added IW61x support to the mwifiex driver and besides the VDLL
> > handling which must be added I didn't notice any differences. There
> > might be other differences, but I doubt that these can't be integrated
> > into the mwifiex driver.
>
> Maybe you can share an RFC patch with what you currently have available
> to support IW61x within the current mwifiex driver?
I just did, see:
https://lore.kernel.org/linux-wireless/20240826072648.167004-1-s.hauer@pengutronix.de/
Sascha
--
Pengutronix e.K. | |
Steuerwalder Str. 21 | http://www.pengutronix.de/ |
31137 Hildesheim, Germany | Phone: +49-5121-206917-0 |
Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 |
next prev parent reply other threads:[~2024-08-26 7:43 UTC|newest]
Thread overview: 71+ messages / expand[flat|nested] mbox.gz Atom feed top
2024-08-09 9:44 [PATCH v2 00/43] wifi: nxpwifi: create nxpwifi to support iw61x David Lin
2024-08-09 9:44 ` [PATCH v2 01/43] wifi: nxpwifi: add 11ac.c David Lin
2024-08-09 9:44 ` [PATCH v2 02/43] wifi: nxpwifi: add 11ac.h David Lin
2024-08-09 9:44 ` [PATCH v2 03/43] wifi: nxpwifi: add 11h.c David Lin
2024-08-09 9:44 ` [PATCH v2 04/43] wifi: nxpwifi: add 11n_aggr.c David Lin
2024-08-09 9:44 ` [PATCH v2 05/43] wifi: nxpwifi: add 11n_aggr.h David Lin
2024-08-09 9:44 ` [PATCH v2 06/43] wifi: nxpwifi: add 11n.c David Lin
2024-08-09 9:44 ` [PATCH v2 07/43] wifi: nxpwifi: add 11n.h David Lin
2024-08-09 9:44 ` [PATCH v2 08/43] wifi: nxpwifi: add 11n_rxreorder.c David Lin
2024-08-09 9:44 ` [PATCH v2 09/43] wifi: nxpwifi: add 11n_rxreorder.h David Lin
2024-08-09 9:45 ` [PATCH v2 10/43] wifi: nxpwifi: add cfg80211.c David Lin
2024-08-09 9:45 ` [PATCH v2 11/43] wifi: nxpwifi: add cfg80211.h David Lin
2024-08-09 9:45 ` [PATCH v2 12/43] wifi: nxpwifi: add cfg.h David Lin
2024-08-09 9:45 ` [PATCH v2 13/43] wifi: nxpwifi: add cfp.c David Lin
2024-08-09 9:45 ` [PATCH v2 14/43] wifi: nxpwifi: add cmdevt.c David Lin
2024-08-09 9:45 ` [PATCH v2 15/43] wifi: nxpwifi: add cmdevt.h David Lin
2024-08-09 9:45 ` [PATCH v2 16/43] wifi: nxpwifi: add debugfs.c David Lin
2024-08-09 9:45 ` [PATCH v2 17/43] wifi: nxpwifi: add decl.h David Lin
2024-08-09 9:45 ` [PATCH v2 18/43] wifi: nxpwifi: add ethtool.c David Lin
2024-08-09 9:45 ` [PATCH v2 19/43] wifi: nxpwifi: add fw.h David Lin
2024-08-09 9:45 ` [PATCH v2 20/43] wifi: nxpwifi: add ie.c David Lin
2024-08-09 9:45 ` [PATCH v2 21/43] wifi: nxpwifi: add init.c David Lin
2024-08-09 9:45 ` [PATCH v2 22/43] wifi: nxpwifi: add join.c David Lin
2024-08-09 9:45 ` [PATCH v2 23/43] wifi: nxpwifi: add main.c David Lin
2024-08-09 9:45 ` [PATCH v2 24/43] wifi: nxpwifi: add main.h David Lin
2024-08-09 9:45 ` [PATCH v2 25/43] wifi: nxpwifi: add scan.c David Lin
2024-08-09 9:45 ` [PATCH v2 26/43] wifi: nxpwifi: add sdio.c David Lin
2024-08-09 9:45 ` [PATCH v2 27/43] wifi: nxpwifi: add sdio.h David Lin
2024-08-09 9:45 ` [PATCH v2 28/43] wifi: nxpwifi: add sta_cfg.c David Lin
2024-08-09 9:45 ` [PATCH v2 29/43] wifi: nxpwifi: add sta_cmd.c David Lin
2024-08-09 9:45 ` [PATCH v2 30/43] wifi: nxpwifi: add sta_event.c David Lin
2024-08-09 9:45 ` [PATCH v2 31/43] wifi: nxpwifi: add sta_rx.c David Lin
2024-08-09 9:45 ` [PATCH v2 32/43] wifi: nxpwifi: add sta_tx.c David Lin
2024-08-09 9:45 ` [PATCH v2 33/43] wifi: nxpwifi: add txrx.c David Lin
2024-08-09 9:45 ` [PATCH v2 34/43] wifi: nxpwifi: add uap_cmd.c David Lin
2024-08-09 9:45 ` [PATCH v2 35/43] wifi: nxpwifi: add uap_event.c David Lin
2024-08-09 9:45 ` [PATCH v2 36/43] wifi: nxpwifi: add uap_txrx.c David Lin
2024-08-09 9:45 ` [PATCH v2 37/43] wifi: nxpwifi: add util.c David Lin
2024-08-09 9:45 ` [PATCH v2 38/43] wifi: nxpwifi: add util.h David Lin
2024-08-09 9:45 ` [PATCH v2 39/43] wifi: nxpwifi: add wmm.c David Lin
2024-08-09 9:45 ` [PATCH v2 40/43] wifi: nxpwifi: add wmm.h David Lin
2024-08-14 18:48 ` Greg KH
2024-08-15 1:52 ` [EXT] " David Lin
2024-08-15 5:08 ` Greg KH
2024-08-15 6:20 ` David Lin
2024-08-15 6:23 ` David Lin
2024-08-15 6:57 ` Greg KH
2024-08-15 9:51 ` Kalle Valo
2024-08-16 1:39 ` David Lin
2024-08-15 9:43 ` Kalle Valo
2024-08-15 9:58 ` Greg KH
2024-08-15 11:44 ` Kalle Valo
2024-08-09 9:45 ` [PATCH v2 41/43] wifi: nxpwifi: add nxp sdio vendor id and iw61x device id David Lin
2024-08-09 9:45 ` [PATCH v2 42/43] wifi: nxpwifi: add Makefile and Kconfig files for nxpwifi compilation David Lin
2024-08-09 9:45 ` [PATCH v2 43/43] wifi: nxpwifi: add nxpwifi related information to MAINTAINERS David Lin
2024-08-14 3:47 ` [PATCH v2 00/43] wifi: nxpwifi: create nxpwifi to support iw61x David Lin
2024-08-15 9:35 ` Kalle Valo
2024-08-16 5:32 ` [EXT] " David Lin
2024-08-22 12:56 ` Sascha Hauer
2024-08-24 13:48 ` Francesco Dolcini
2024-08-26 2:30 ` [EXT] " David Lin
2024-08-26 7:43 ` Sascha Hauer [this message]
2024-08-25 20:37 ` Calvin Owens
2024-08-26 2:33 ` [EXT] " David Lin
2024-08-26 2:49 ` Calvin Owens
2024-08-26 2:56 ` David Lin
2024-08-26 5:30 ` Calvin Owens
2024-08-26 5:49 ` David Lin
2024-10-17 7:48 ` Kalle Valo
2024-12-11 3:52 ` [EXT] " David Lin
2025-01-10 5:31 ` Jeff Chen
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=ZswyBSyDC8it95Zt@pengutronix.de \
--to=s.hauer@pengutronix.de \
--cc=briannorris@chromium.org \
--cc=francesco@dolcini.it \
--cc=johannes@sipsolutions.net \
--cc=kernel@pengutronix.de \
--cc=kvalo@kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-wireless@vger.kernel.org \
--cc=tsung-hsien.hsieh@nxp.com \
--cc=yu-hao.lin@nxp.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).