From: Neil Armstrong <narmstrong@baylibre.com>
To: Marek Szyprowski <m.szyprowski@samsung.com>,
linux-wireless@vger.kernel.org,
brcm80211-dev-list.pdl@broadcom.com,
linux-amlogic@lists.infradead.org,
"linux-mmc@vger.kernel.org" <linux-mmc@vger.kernel.org>
Cc: Arend van Spriel <aspriel@gmail.com>,
Chung-hsien Hsu <chung-hsien.hsu@infineon.com>,
Bartlomiej Zolnierkiewicz <b.zolnierkie@samsung.com>,
martin.blumenstingl@googlemail.com,
Dmitry Lebed <lebed.dmitry@gmail.com>,
Hante Meuleman <hante.meuleman@broadcom.com>,
Wright Feng <wright.feng@infineon.com>,
Chi-hsien Lin <chi-hsien.lin@infineon.com>,
Heiner Kallweit <hkallweit1@gmail.com>,
Franky Lin <franky.lin@broadcom.com>
Subject: Re: brcmfmac and unaligned sdio access on Khadas VIM3L
Date: Wed, 10 Feb 2021 09:17:32 +0100 [thread overview]
Message-ID: <ab81cc00-049f-67a5-bc97-417d7cd2fa44@baylibre.com> (raw)
In-Reply-To: <967b6bfe-a612-707f-583e-c45d61acffe0@samsung.com>
Hi,
On 09/02/2021 13:48, Marek Szyprowski wrote:
> Hi
>
> I've noticed that the Broadcom Wifi chip performs unaligned SDIO access
> during the station scan on Khadas VIM3l board. This issue went unnoticed
> so far, because there was a workaround in the meson MMC driver, which
> has been recently disabled by commit e085b51c74cc ("mmc: meson-gx: check
> for scatterlist size alignment in block mode") from current linux-next.
>
> I can easily reproduce this issue with the following commands:
>
> # dmesg | grep brcm
> [ 11.659351] Bluetooth: hci0: BCM4359C0 'brcm/BCM4359C0.hcd' Patch
> [ 13.079767] brcmfmac: brcmf_fw_alloc_request: using
> brcm/brcmfmac4359-sdio for chip BCM4359/9
> [ 13.527363] brcmfmac: brcmf_fw_alloc_request: using
> brcm/brcmfmac4359-sdio for chip BCM4359/9
> [ 13.601269] brcmfmac: brcmf_c_process_clm_blob: no clm_blob available
> (err=-11), device may have limited channels available
> [ 13.619414] brcmfmac: brcmf_c_preinit_dcmds: Firmware: BCM4359/9 wl0:
> Mar 6 2017 10:16:06 version 9.87.51.7 (r686312) FWID 01-4dcc75d9
> # ifconfig wlan0 up
> [ 208.052058] ieee80211 phy0: brcmf_dongle_roam: WLC_SET_ROAM_TRIGGER
> error (-52)
> # iw wlan0 scan >/dev/null
> [ 218.148345] ------------[ cut here ]------------
> [ 218.148501] unaligned sg len 504 blksize 256
> [ 218.153712] WARNING: CPU: 1 PID: 75 at
> drivers/mmc/host/meson-gx-mmc.c:251
> meson_mmc_get_transfer_mode.isra.10+0xf8/0x130
> [ 218.162616] Modules linked in: ipv6 brcmfmac brcmutil cfg80211
> dw_hdmi_cec dw_hdmi_i2s_audio hci_uart btqca btbcm bluetooth
> ecdh_generic ecc crct10dif_ce rfkill panfrost
> snd_soc_meson_axg_sound_card snd_soc_meson_card_utils gpu_sched
> meson_gxbb_wdt rtc_hym8563 pwm_meson meson_gxl rtc_meson_vrtc rc_khadas
> meson_ir reset_meson_audio_arb realtek snd_soc_meson_g12a_tohdmitx
> snd_soc_meson_codec_glue snd_soc_meson_axg_tdmout
> snd_soc_meson_axg_frddr snd_soc_meson_axg_fifo axg_audio sclk_div
> clk_phase mdio_mux_meson_g12a meson_dw_hdmi meson_drm meson_rng
> dwmac_generic snd_soc_meson_axg_tdm_interface meson_canvas rng_core
> dw_hdmi snd_soc_meson_axg_tdm_formatter dwmac_meson8b stmmac_platform
> stmmac display_connector adc_keys pcs_xpcs nvmem_meson_efuse
> [ 218.228329] CPU: 1 PID: 75 Comm: kworker/u8:2 Not tainted
> 5.11.0-rc6-next-20210208 #2492
> [ 218.236343] Hardware name: Khadas VIM3L (DT)
> [ 218.240579] Workqueue: brcmf_wq/mmc2:0001:1 brcmf_sdio_dataworker
> [brcmfmac]
> [ 218.247559] pstate: 60400009 (nZCv daif +PAN -UAO -TCO BTYPE=--)
> [ 218.253506] pc : meson_mmc_get_transfer_mode.isra.10+0xf8/0x130
> [ 218.259372] lr : meson_mmc_get_transfer_mode.isra.10+0xf8/0x130
> [ 218.265237] sp : ffff80001327b870
> [ 218.268514] x29: ffff80001327b870 x28: 0000000000000003
> [ 218.273776] x27: 0000000000000218 x26: 0000000000000600
> [ 218.279036] x25: ffff000003a17678 x24: 0000000000000000
> [ 218.284296] x23: ffff8000121cfae8 x22: ffff800011b54000
> [ 218.289559] x21: ffff80001327bb18 x20: ffff00000277d000
> [ 218.294819] x19: ffff80001327ba40 x18: 00000002faf07f80
> [ 218.300081] x17: 0000000000004000 x16: 0000000000000000
> [ 218.305341] x15: 0000000000000380 x14: 0000000000000000
> [ 218.310603] x13: 0000000000000080 x12: 0000000000000000
> [ 218.315865] x11: 0000000000000000 x10: 0000000000001370
> [ 218.321125] x9 : ffff00006f995258 x8 : 000000009e0e7ca7
> [ 218.326387] x7 : ffff80001327b4a0 x6 : 0000000000000001
> [ 218.331648] x5 : 0000000000000001 x4 : 0000000000000000
> [ 218.336912] x3 : 0000000000000002 x2 : ffff8000121f4768
> [ 218.342171] x1 : 42fe1bd05e5eaa00 x0 : 0000000000000000
> [ 218.347435] Call trace:
> [ 218.349854] meson_mmc_get_transfer_mode.isra.10+0xf8/0x130
> [ 218.355368] meson_mmc_request+0x74/0xb0
> [ 218.359250] __mmc_start_request+0xa4/0x2b0
> [ 218.363390] mmc_start_request+0x80/0xa8
> [ 218.367272] mmc_wait_for_req+0x68/0xd8
> [ 218.371066] mmc_submit_one.isra.17+0x78/0x148 [brcmfmac]
> [ 218.376416] brcmf_sdiod_sglist_rw+0x324/0x4a8 [brcmfmac]
> [ 218.381762] brcmf_sdiod_recv_chain+0x70/0x140 [brcmfmac]
> [ 218.387110] brcmf_sdio_dataworker+0x614/0x17d0 [brcmfmac]
> [ 218.392545] process_one_work+0x2a8/0x728
> [ 218.396510] worker_thread+0x48/0x460
> [ 218.400132] kthread+0x134/0x160
> [ 218.403323] ret_from_fork+0x10/0x18
> [ 218.406862] irq event stamp: 15834
> [ 218.410222] hardirqs last enabled at (15833): [<ffff800010f95804>]
> _raw_spin_unlock_irq+0x3c/0x80
> [ 218.419107] hardirqs last disabled at (15834): [<ffff800010f895ac>]
> el1_dbg+0x24/0x50
> [ 218.426869] softirqs last enabled at (15828): [<ffff800010010508>]
> _stext+0x508/0x638
> [ 218.434717] softirqs last disabled at (15823): [<ffff8000100952ec>]
> irq_exit+0x19c/0x1a8
> [ 218.442739] ---[ end trace dfc38bb4458b4c37 ]---
> #
>
> Surprisingly the same commands executed on the Khadas VIM3 board with
> the same kernel don't trigger the warning.
This may be because the VIM3 (G12A & G12B) has a broken SDIO controller using
an internal SRAM as bounce buffer instead of the scatter/gather DMA, cf amlogic,dram-access-quirk.
>
> Let me know if I can help debugging this issue.
Simply remove the WARN_ONCE()...
>
> Best regards
>
Thanks for the report,
Neil
next prev parent reply other threads:[~2021-02-10 8:18 UTC|newest]
Thread overview: 6+ messages / expand[flat|nested] mbox.gz Atom feed top
[not found] <CGME20210209124819eucas1p29c9b481ef524a753ce79aa6ab580d0a7@eucas1p2.samsung.com>
2021-02-09 12:48 ` brcmfmac and unaligned sdio access on Khadas VIM3L Marek Szyprowski
2021-02-10 8:17 ` Neil Armstrong [this message]
2021-02-10 8:45 ` Marek Szyprowski
2021-02-10 8:52 ` Neil Armstrong
2021-04-07 8:45 ` Neil Armstrong
2021-04-07 10:00 ` Marek Szyprowski
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=ab81cc00-049f-67a5-bc97-417d7cd2fa44@baylibre.com \
--to=narmstrong@baylibre.com \
--cc=aspriel@gmail.com \
--cc=b.zolnierkie@samsung.com \
--cc=brcm80211-dev-list.pdl@broadcom.com \
--cc=chi-hsien.lin@infineon.com \
--cc=chung-hsien.hsu@infineon.com \
--cc=franky.lin@broadcom.com \
--cc=hante.meuleman@broadcom.com \
--cc=hkallweit1@gmail.com \
--cc=lebed.dmitry@gmail.com \
--cc=linux-amlogic@lists.infradead.org \
--cc=linux-mmc@vger.kernel.org \
--cc=linux-wireless@vger.kernel.org \
--cc=m.szyprowski@samsung.com \
--cc=martin.blumenstingl@googlemail.com \
--cc=wright.feng@infineon.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox