Re: [PATCH V3 1/9] brcmfmac: merge two brcmf_err macros into one

[Arend Van Spriel <arend.vanspriel@broadcom.com>]

On 2-2-2017 22:33, Rafał Miłecki wrote:
> From: Rafał Miłecki <rafal@milecki.pl>
> 
> This allows simplifying the code by adding a simple IS_ENABLED check for
> CONFIG_BRCMDB symbol.

Acked-by: Arend van Spriel <arend.vanspriel@broadcom.com>
> Signed-off-by: Rafał Miłecki <rafal@milecki.pl>
> ---
> V3: Re-add this patch (it was initially submited as RFC)
> ---
>  drivers/net/wireless/broadcom/brcm80211/brcmfmac/debug.h | 8 ++------
>  1 file changed, 2 insertions(+), 6 deletions(-)
> 
> diff --git a/drivers/net/wireless/broadcom/brcm80211/brcmfmac/debug.h b/drivers/net/wireless/broadcom/brcm80211/brcmfmac/debug.h
> index 6687812770cc..1fe4aa973a92 100644
> --- a/drivers/net/wireless/broadcom/brcm80211/brcmfmac/debug.h
> +++ b/drivers/net/wireless/broadcom/brcm80211/brcmfmac/debug.h
> @@ -45,20 +45,16 @@
>  #undef pr_fmt
>  #define pr_fmt(fmt)		KBUILD_MODNAME ": " fmt
>  
> +#ifndef CONFIG_BRCM_TRACING
>  /* Macro for error messages. net_ratelimit() is used when driver
>   * debugging is not selected. When debugging the driver error
>   * messages are as important as other tracing or even more so.
>   */
> -#ifndef CONFIG_BRCM_TRACING
> -#ifdef CONFIG_BRCMDBG
> -#define brcmf_err(fmt, ...)	pr_err("%s: " fmt, __func__, ##__VA_ARGS__)
> -#else
>  #define brcmf_err(fmt, ...)						\
>  	do {								\
> -		if (net_ratelimit())					\
> +		if (IS_ENABLED(CONFIG_BRCMDBG) || net_ratelimit())	\
>  			pr_err("%s: " fmt, __func__, ##__VA_ARGS__);	\
>  	} while (0)
> -#endif
>  #else
>  __printf(2, 3)
>  void __brcmf_err(const char *func, const char *fmt, ...);
>