From: Jeff Liu <jeff.liu@oracle.com>
To: "xfs@oss.sgi.com" <xfs@oss.sgi.com>
Subject: [PATCH v2 RESEND] xfs: fix dead loop at xfs_vm_writepage() on 32bit machine
Date: Wed, 25 Sep 2013 16:10:20 +0800 [thread overview]
Message-ID: <52429A6C.3050908@oracle.com> (raw)
From: Jie Liu <jeff.liu@oracle.com>
Write a file with an offset greater than 16TB on 32-bit system and
then trigger page write-back via sync(1) as below will cause the
task hang in a little while:
# block_size=4096
# offset=$(((2**32 - 1) * $block_size))
# xfs_io -f -c "pwrite $offset $block_size" /storage/test_file
# sync
INFO: task sync:2590 blocked for more than 120 seconds.
"echo 0 > /proc/sys/kernel/hung_task_timeout_secs" disables this message.
sync D c1064a28 0 2590 2097 0x00000000
.....
Call Trace:
[<c1064a28>] ? ttwu_do_wakeup+0x18/0x130
[<c1066d0e>] ? try_to_wake_up+0x1ce/0x220
[<c1066dbf>] ? wake_up_process+0x1f/0x40
[<c104fc2e>] ? wake_up_worker+0x1e/0x30
[<c15b6083>] schedule+0x23/0x60
[<c15b3c2d>] schedule_timeout+0x18d/0x1f0
[<c12a143e>] ? do_raw_spin_unlock+0x4e/0x90
[<c10515f1>] ? __queue_delayed_work+0x91/0x150
[<c12a12ef>] ? do_raw_spin_lock+0x3f/0x100
[<c12a143e>] ? do_raw_spin_unlock+0x4e/0x90
[<c15b5b5d>] wait_for_completion+0x7d/0xc0
[<c1066d60>] ? try_to_wake_up+0x220/0x220
[<c116a4d2>] sync_inodes_sb+0x92/0x180
[<c116fb05>] sync_inodes_one_sb+0x15/0x20
[<c114a8f8>] iterate_supers+0xb8/0xc0
[<c116faf0>] ? fdatawrite_one_bdev+0x20/0x20
[<c116fc21>] sys_sync+0x31/0x80
[<c15be18d>] sysenter_do_call+0x12/0x28
The reason is that the end_index is unsigned long with maximum value
'2^32-1=4294967295' on 32-bit platform, and the given offset cause it
wrapped to 0, so that the following codes will repeat again and again
until the task schedule time out:
end_index = offset >> PAGE_CACHE_SHIFT;
last_index = (offset - 1) >> PAGE_CACHE_SHIFT;
if (page->index >= end_index) {
unsigned offset_into_page = offset & (PAGE_CACHE_SIZE - 1);
/*
* Just skip the page if it is fully outside i_size, e.g. due
* to a truncate operation that is in progress.
*/
if (page->index >= end_index + 1 || offset_into_page == 0) {
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
unlock_page(page);
return 0;
}
To check a page is fully outsids i_size or not, we can change the
logic to:
if (page->index > end_index ||
(page->index == end_index && offset_into_page == 0))
Secondly, there still has another similar issue when calculating the
end offset for mapping the filesystem blocks to the file blocks for
delalloc. With the same tests to above, run unmount(8) will cause
kernel panic if CONFIG_XFS_DEBUG is enabled:
XFS: Assertion failed: XFS_FORCED_SHUTDOWN(ip->i_mount) || \
ip->i_delayed_blks == 0, file: fs/xfs/xfs_super.c, line: 964
kernel BUG at fs/xfs/xfs_message.c:108!
invalid opcode: 0000 [#1] SMP
task: edddc100 ti: ec6ee000 task.ti: ec6ee000
EIP: 0060:[<f83d87cb>] EFLAGS: 00010296 CPU: 1
EIP is at assfail+0x2b/0x30 [xfs]
..............
Call Trace:
[<f83d9cd4>] xfs_fs_destroy_inode+0x74/0x120 [xfs]
[<c115ddf1>] destroy_inode+0x31/0x50
[<c115deff>] evict+0xef/0x170
[<c115dfb2>] dispose_list+0x32/0x40
[<c115ea3a>] evict_inodes+0xca/0xe0
[<c1149706>] generic_shutdown_super+0x46/0xd0
[<c11497b9>] kill_block_super+0x29/0x70
[<c1149a14>] deactivate_locked_super+0x44/0x70
[<c114a427>] deactivate_super+0x47/0x60
[<c1161c3d>] mntput_no_expire+0xcd/0x120
[<c1162ae8>] SyS_umount+0xa8/0x370
[<c1162dce>] SyS_oldumount+0x1e/0x20
[<c15be18d>] sysenter_do_call+0x12/0x28
That because the end_offset is evaluated to 0 same to above, hence the
mapping and covertion for dealloc file blocks to file system blocks did
not happened.
This patch just fixed both issues.
Reported-by: Michael L. Semon <mlsemon35@gmail.com>
Signed-off-by: Jie Liu <jeff.liu@oracle.com>
---
v2: don't reset the s_max_bytes to MAX_LFS_FILESIZE, instead, revise the page offset
check up strategy to avoid the potential overflow.
v1: http://oss.sgi.com/archives/xfs/2013-07/msg00154.html
fs/xfs/xfs_aops.c | 11 ++++++-----
1 file changed, 6 insertions(+), 5 deletions(-)
diff --git a/fs/xfs/xfs_aops.c b/fs/xfs/xfs_aops.c
index 41a6950..6059d00 100644
--- a/fs/xfs/xfs_aops.c
+++ b/fs/xfs/xfs_aops.c
@@ -969,7 +969,9 @@ xfs_vm_writepage(
offset = i_size_read(inode);
end_index = offset >> PAGE_CACHE_SHIFT;
last_index = (offset - 1) >> PAGE_CACHE_SHIFT;
- if (page->index >= end_index) {
+ if (page->index < end_index)
+ end_offset = (xfs_off_t)(page->index + 1) << PAGE_CACHE_SHIFT;
+ else {
unsigned offset_into_page = offset & (PAGE_CACHE_SIZE - 1);
/*
@@ -978,7 +980,8 @@ xfs_vm_writepage(
* page so that reclaim stops reclaiming it. Otherwise
* xfs_vm_releasepage() is called on it and gets confused.
*/
- if (page->index >= end_index + 1 || offset_into_page == 0)
+ if (page->index > end_index ||
+ (page->index == end_index && offset_into_page == 0))
goto redirty;
/*
@@ -990,11 +993,9 @@ xfs_vm_writepage(
* not written out to the file."
*/
zero_user_segment(page, offset_into_page, PAGE_CACHE_SIZE);
+ end_offset = offset;
}
- end_offset = min_t(unsigned long long,
- (xfs_off_t)(page->index + 1) << PAGE_CACHE_SHIFT,
- offset);
len = 1 << inode->i_blkbits;
bh = head = page_buffers(page);
-- 1.7.9.5
_______________________________________________
xfs mailing list
xfs@oss.sgi.com
http://oss.sgi.com/mailman/listinfo/xfs
next reply other threads:[~2013-09-25 8:09 UTC|newest]
Thread overview: 3+ messages / expand[flat|nested] mbox.gz Atom feed top
2013-09-25 8:10 Jeff Liu [this message]
2013-09-25 21:32 ` [PATCH v2 RESEND] xfs: fix dead loop at xfs_vm_writepage() on 32bit machine Dave Chinner
2013-09-26 4:12 ` Jeff Liu
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=52429A6C.3050908@oracle.com \
--to=jeff.liu@oracle.com \
--cc=xfs@oss.sgi.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox