Hello All,
My board uses a MPC823 and SCC2 as its ethernet interface.
display "nfs: server 192.168.0.82 not responding, still
trying"
"nfs: server
192.168.0.82 OK"
when boot with linux-2.4.25, but ok with
linux-2.4.4
Below is what it looks like when booting.
boot with linux-2.4.25:
eth0: CPM ENET Version 0.2 on SCC2,
42:dd:0c:46:e8:b8
RAMDISK driver initialized: 16 RAM disks of 4096K size 1024
blocksize
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP,
TCP
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables
configured (established 2048 bind 4096)
IP-Config:
Complete:
device=eth0, addr=192.168.0.182,
mask=255.255.255.0, gw=192.168.0.1,
host=192.168.0.182, domain=, nis-domain=(none),
bootserver=192.168.0.82, rootserver=192.168.0.82, rootpath=
NET4: Unix domain
sockets 1.0/SMP for Linux NET4.0.
Looking up port of RPC 100003/2 on
192.168.0.82
Looking up port of RPC 100005/1 on 192.168.0.82
VFS: Mounted
root (nfs filesystem).
Freeing unused kernel memory: 52k init
nfs: server
192.168.0.82 not responding, still trying
nfs: server 192.168.0.82 OK
nfs:
server 192.168.0.82 not responding, still trying
nfs: server 192.168.0.82 not
responding, still trying
nfs: server 192.168.0.82 OK
nfs: server
192.168.0.82
OK
Welcome to Sinovee Linux 2.0
(Overlord)
Press 'I' to enter interactive startup.
Mounting proc filesystem: nfs:
server 192.168.0.82 not responding, still trying
nfs: server 192.168.0.82
OK
[ OK ]
Configuring kernel parameters: [
OK ]
Setting clock (utc): Wed Jun 22 17:36:00 CST 2005 [ OK
]
Activating swap partitions: [ OK ]
Setting hostname
192.168.0.182: [ OK ]
Starting watchdog: [OK]
Watchdog
daemon ver 0.1, (c) 2002, FEL co. ltd.
watchdog: No such device
INIT:
Entering runlevel: 3
Entering non-interactive startup
Starting xinetd:
nfs: server 192.168.0.82 not responding, still trying
nfs: server
192.168.0.82 OK
[ OK ]
Sinovee Linux 2.0 (Overlord)
Kernel 2.4.4 on an
MPC8xx
192 login: root
nfs: server 192.168.0.82 not responding, still
trying
nfs: server 192.168.0.82 OK
sh-2.04#
sh-2.04#
boot with linux-2.4.4:
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
Kernel command line: root=/dev/nfs rw console=ttyS0,19200
nfsroot=192.168.0.82:/
prj/sc8xx/root
ip=192.168.0.182:192.168.0.82:192.168.0.1:255.255.255.0::eth0:off
Decrementer
Frequency: 4687500
Calibrating delay loop... 74.75 BogoMIPS
Memory: 30744k
available (1004k kernel code, 376k data, 48k init, 0k highmem)
Dentry-cache
hash table entries: 4096 (order: 3, 32768 bytes)
Buffer-cache hash table
entries: 1024 (order: 0, 4096 bytes)
Page-cache hash table entries: 8192
(order: 3, 32768 bytes)
Inode-cache hash table entries: 2048 (order: 2, 16384
bytes)
POSIX conformance testing by UNIFIX
Linux NET4.0 for Linux
2.4
Based upon Swansea University Computer Society NET3.039
Starting
kswapd v1.8
CPM UART driver version 0.03
ttyS0 on SMC1 at 0x0280,
BRG1
ttyS1 on SMC2 at 0x0380, BRG2
pty: 256 Unix98 ptys
configured
WDT_8xx: SWT not enabled by firmware, SYPCR=0xffffff88
block:
queued sectors max/low 20357kB/6785kB, 64 slots per queue
RAMDISK driver
initialized: 16 RAM disks of 6144K size 1024 blocksize
eth0: CPM ENET Version
0.21 on SCC2, 42:dd:0c:46:e8:b8
loop: loaded (max 8 devices)
Using
configured DiskOnChip probe address 0x80000000
DiskOnChip 2000 found at
address 0x80000000
Flash chip found: Manufacturer ID: 98, Chip ID: 75
(Toshiba TC58256FT/DC)
1 flash chips found. Total DiskOnChip size: 32
MiB
NFTL driver: nftlcore.c $Revision: 1.83 $, nftlmount.c $Revision: 1.23
$
Cannot calculate an NFTL geometry to match size of 0xf760.
Using C:989
H:16 S:4 (== 0xf740 sects)
Partition check:
nftla: nftla1
NET4:
Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP
IP: routing cache
hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established
2048 bind 2048)
NET4: Unix domain sockets 1.0/SMP for Linux
NET4.0.
Looking up port of RPC 100003/2 on 192.168.0.82
Looking up port of
RPC 100005/2 on 192.168.0.82
VFS: Mounted root (nfs filesystem).
Freeing
unused kernel memory: 48k init
INIT: version 2.78
booting
Welcome to Sinovee Linux 2.0
(Overlord)
Press 'I' to enter interactive startup.
Mounting proc filesystem: [ OK ]
Configuring kernel
parameters: [ OK ]
Setting clock (utc): Fri Jun 24 02:00:28
CST 2005 [ OK ]
Activating swap partitions: [
OK ]
Setting hostname 192.168.0.182: [ OK
]
Starting watchdog: Watchdog daemon ver 0.1, (c) 2002, FEL co.
ltd.
watchdog: No such device
[OK]
INIT: Entering runlevel:
3
Entering non-interactive startup
Starting xinetd: [ OK
]
Sinovee Linux 2.0 (Overlord)
Kernel 2.4.4 on an MPC8xx
192 login: