Re: [Linux-ATM-General] Announcement: MPHY now supported inmpc860sar

["Zoran Stojsavljevic" <zoransto@dkts.co.yu>]

Quick question to you all... I walked through Pete's 8260 ATM driver,
and I saw (as far as I can understand) that Pete's driver is set to
support single PHY mode.

So, the question here is: do we need Rodolfo Giometti's patch to be
applied to mpc8260 ATM driver?

It is obvious that different set-up should be applied for mpc8260 ATM
driver MPHY mode anyway...

Thank you for answers in advance.

Regards,
Zoran Stojsavljevic
DKTS Pupin Telecom

----- Original Message -----
From: "Gilad Rom" <gilad@romat.com>
Sent: Monday, January 26, 2004 3:03 PM
Subject: Re: [Linux-ATM-General] Announcement: MPHY now supported in mpc860sar

> And now for my next question - Do you think the driver should run on
> the 82xx family of chips? (e.g. 8260 and the likes) these guys have 2
> Utopia-II ports with support for up to 31 devices per port. Coupled
> with this software, it could make for a highly efficient DSLAM.
>
> ----- Original Message -----
> From: "Alex Zeffertt" <ajz@cambridgebroadband.com>
> Sent: Monday, January 26, 2004 3:59 PM
> Subject: Re: [Linux-ATM-General] Announcement: MPHY now supported in mpc860sar
>
> > It is currently only supported in SAR mode, and in that mode there
> > is an upper limit of 4 UTOPIA phys. However, there's no reason that
> > support can't be added for MPHY in ESAR mode - in which the limit is
> > 31 phys. I suspect that adding such support would be easier now that
> > Rodolfo has done most of the work.
> >
> > PS I'm not the expert on this. Rodolfo's sourceforge username is
> > "zaigor".
> >
> > On Mon, 2004-01-26 at 13:51, Gilad Rom wrote:
> > > This is very exciting news! (well, for me it is)
> > >
> > > How many PHY's in parallel are we talking about here?
> > >
> > > ----- Original Message -----
> > > From: "Alex Zeffertt" <ajz@cambridgebroadband.com>
> > > Sent: Monday, January 26, 2004 1:41 PM
> > > Subject: [Linux-ATM-General] Announcement: MPHY now supported in mpc860sar
> > >
> > > > Just a quick note to say that multi-phy is now supported by the
> > > > mpc860sar ATM driver, thanks to a patch by Rodolfo Giometti.
> > > >
> > > > Page: http://sourceforge.net/projects/mpc860sar/

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/