MPC8260 Hang

MPC8260 Hang

[challaharikumar]

Hi!
All ...

I having been trying to bring up the ADS8260 board and incidentally ran
into some problems.

I initially tried using Linux 2.4.1 kernel and it worked fine and the
board was up.

I upgraded to 2.4.17 and I found out that the system started hanging
during boot up.

I compiled 2.4.17 for ppc boot. (I already have ppc boot on my ADS board
and I test my development by tftp boot'ing the kernel image.

I tried tracking down where the hang could be and ended up at the RFI
instruction where its waiting to complete the MMU initialization. The
system executes SYNC instruction and then hangs. (arch/ppc/kernel/head.S)

I tried comparing the file head.S between 2.4.1 and 2.4.17. I found out
some patches done inside the 2.4.1 had been made generic. There were
patches for the BAT initialization and RAM mapping on the MPC8260.

Is there an update on the files?
Should the patches be done for 2.4.17 as well ?

Any suggestions or pointers could be very helpful.

[Running on x86 with Red Hat 8.0 and cross compiling for PPC.]


regards
Hari

** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/

Re: MPC8260 Hang

[Wolfgang Denk]

In message <004101c42900$c082e880$3401080a@telxsi.com> you wrote:
>
> I having been trying to bring up the ADS8260 board and incidentally ran
> into some problems.

You posted the very same question yesterday, and received two replies
which should help solving your problem (which  basicly  results  from
not reading the FAQ).

Now you ignore the replies, and ask the same stuff again?

What exactly do you want?


Wolfgang Denk

--
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-4596-87  Fax: (+49)-8142-4596-88  Email: wd@denx.de
The light at the end of the tunnel is usually a "No Exit" sign.

** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/