Problem bringing up Linux on Custom MPC522 Board

Problem bringing up Linux on Custom MPC522 Board

[Chris Down]

I am trying to bring up Linux (latest linuxppc-2.4 tree) on a custom =
MPC852
Board. The board has 8MByte SDRAM and 8MByte Flash.=20
I have ported u-boot, modified Linux to add a new board config and added =
the
board specific definitions in arch/ppc/platforms.=20
U-Boot and Linux were built using the ppc_8xx compiler from ELDK 3.0.

When I boot Linux I get the following:-

## Booting image at 00100000 ...
   Image Name:   Linux-2.4.28-pre3-cdd1
   Image Type:   PowerPC Linux Kernel Image (gzip compressed)
   Data Size:    664920 Bytes =3D 649.3 kB
   Load Address: 00000000
   Entry Point:  00000000
   Verifying Checksum ... OK
   Uncompressing Kernel Image ... OK
Linux version 2.4.28-pre3-cdd1 (chris@alioth) (gcc version 3.2.2 =
20030217 (Yello
w Dog Linux 3.0 3.2.2-2a_1)) #3 Fri Nov 12 09:46:59 GMT 2004
On node 0 totalpages: 2048
zone(0): 2048 pages.
zone(1): 0 pages.
zone(2): 0 pages.
Kernel command line:
Decrementer Frequency =3D 187500000/60
Calibrating delay loop... 49.76 BogoMIPS
Memory: 6508k available (1176k kernel code, 344k data, 56k init, 0k =
highmem)
Dentry cache hash table entries: 1024 (order: 1, 8192 bytes)
Inode cache hash table entries: 512 (order: 0, 4096 bytes)
Mount cache hash table entries: 512 (order: 0, 4096 bytes)
Buffer cache hash table entries: 1024 (order: 0, 4096 bytes)
Page-cache hash table entries: 2048 (order: 1, 8192 bytes)
POSIX conformance testing by UNIFIX

At this point it stops executing in arch_kernel_thread.

As I am new to this I could do with some pointers as to what to do next. =
Any
help would be gratefully appreciated.


Regards

Chris Down