From mboxrd@z Thu Jan 1 00:00:00 1970 Reply-To: From: "kotaeji" To: Subject: [Q] question about using x86 gdb to debug the remote ppc target (kgdb) Date: Fri, 9 Jan 2004 14:41:10 +0900 Message-ID: <006701c3d673$30cb7890$2c373737@hwteam6549> MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Sender: owner-linuxppc-embedded@lists.linuxppc.org List-Id: Hi, I have a question about using kgdb on PowerPC (8245) Is it possible that the host is x86, and the remote target is powerpc as following picture ? HOST(x86) ----------------------------- TARGET(ppc) gdb serial line kgdb patch When I connect to target by gdb on x86 and do "info registers" to show target registers, it shows x86 registers. (gdb) info registers eax 0x2000 8192 ecx 0xc3c6dd00 -1010377472 edx 0xc3c6c000 -1010384896 ebx 0xc0341540 -1070328512 esp 0xc0341400 0xc0341400 ebp 0xc3c6dd80 0xc3c6dd80 esi 0xc3c6de4c -1010377140 edi 0x280008e8 671090920 eip 0x0 0x0 eflags 0x2 2 cs 0x0 0 ss 0xc5000000 -989855744 ds 0xfed2a80 267201152 es 0x10020300 268567296 fs 0x0 0 gs 0x0 0 Is there any way that I can use x86 gdb to debug remote ppc target? Should I use powerpc gdb (like YellowDog) in order to debug ppc target? Any comments appreciated. ** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/