Linux on Ml410

Linux on Ml410

[mojtaba]

Dear all,

I am trying to run linux 1.6.25 on ML410 board. When the system boot I
receive this error:

loaded at:     00400000 004CD19C
board data at: 004CB120 004CB19C
relocated to:  00404050 004040CC
zimage at:     00404E3C 004CA0D1
avail ram:     004CE000 10000000

Linux/PPC load: console=ttyS0,115200 root=/dev/xsa2
Uncompressing Linux...inflate returned FFFFFFFD
exit

I will appreciate it if somebody can kindly answer me?
Regards,
Mojtaba

RE: Linux on Ml410

[John Linn]

Hi Mojtaba,

Did you build the FPGA bit stream yourself or get it from somewhere?

Specifying ttyS0 means you should have a 16550 UART in the hardware
build, do you?

-- John

-----Original Message-----
From: linuxppc-embedded-bounces+john.linn=3Dxilinx.com@ozlabs.org
[mailto:linuxppc-embedded-bounces+john.linn=3Dxilinx.com@ozlabs.org] On
Behalf Of mojtaba
Sent: Tuesday, May 13, 2008 5:37 AM
To: linuxppc-embedded@ozlabs.org
Subject: Linux on Ml410

Dear all,

I am trying to run linux 1.6.25 on ML410 board. When the system boot I
receive this error:

loaded at:     00400000 004CD19C
board data at: 004CB120 004CB19C
relocated to:  00404050 004040CC
zimage at:     00404E3C 004CA0D1
avail ram:     004CE000 10000000

Linux/PPC load: console=3DttyS0,115200 root=3D/dev/xsa2
Uncompressing Linux...inflate returned FFFFFFFD
exit

I will appreciate it if somebody can kindly answer me?
Regards,
Mojtaba

_______________________________________________
Linuxppc-embedded mailing list
Linuxppc-embedded@ozlabs.org
https://ozlabs.org/mailman/listinfo/linuxppc-embedded

Re: Linux on Ml410

[Grant Likely]

On Tue, May 13, 2008 at 5:36 AM, mojtaba <kernelppc@gmail.com> wrote:
> Dear all,
>
>  I am trying to run linux 1.6.25 on ML410 board. When the system boot I
>  receive this error:
>
>  loaded at:     00400000 004CD19C
>  board data at: 004CB120 004CB19C
>  relocated to:  00404050 004040CC
>  zimage at:     00404E3C 004CA0D1
>  avail ram:     004CE000 10000000
>
>  Linux/PPC load: console=ttyS0,115200 root=/dev/xsa2
>  Uncompressing Linux...inflate returned FFFFFFFD
>  exit

Not good.  If you get an error like this during decompression then you
probably have some sort of memory error.  Are you using a reference
design, or have you built a new design?  Have you tested your

It could also be a corrupt kernel image.  How did you build it?  How
large is the image?

Cheers,
g.

-- 
Grant Likely, B.Sc., P.Eng.
Secret Lab Technologies Ltd.