From mboxrd@z Thu Jan 1 00:00:00 1970 Date: Sun, 16 May 1999 13:39:23 -0500 From: strimmer Subject: About Darwin Install, and Sound in linuxppc To: linuxppc-dev@lists.linuxppc.org Message-id: <0FBU00IR56DKQ7@oberlin.edu> MIME-version: 1.0 Content-type: text/plain; charset="US-ASCII" Sender: owner-linuxppc-dev@lists.linuxppc.org List-Id: I know it is off topic for the list, but the darwin list is not helping at all. I finially have an almost working pre-R5. Yeah!! My problem though is the Darwin install says it needs a 1GB drive, but it will not install on my 1.2GB drive. I have about 1.4 GB free in a partition on another drive, but the Darwin installer states it must delete all the data on the drive. Can anyone help me out? Possibly package the installer smaller, or post some image files I can setup using my linuxppc install. Thanks a lot. -Scott =;) P.S. I'm new to kernel compiling, and I can't get an 2.2.6-15apmac kernel to compile that gives me sound. I type make pmac_config make menuconfig (All the Mac dma sound options are on), make dep, make image, make modules, make modules_install. Copy the vmlinux file generated into my system folder and restart. Could someone either send me instructions on where I went wrong, or possibly a working kernel conf file? I have a beige G3 MT/266. I'm running off of my external SCSI drive. 17" Apple 720 Monitor. 64 MB RAM. Thanks again for all of your help. [[ This message was sent via the linuxppc-dev mailing list. Replies are ]] [[ not forced back to the list, so be sure to Cc linuxppc-dev if your ]] [[ reply is of general interest. Please check http://lists.linuxppc.org/ ]] [[ and http://www.linuxppc.org/ for useful information before posting. ]]