Re: [PATCH v2][POWERPC] Always build setup-bus.c on powerpc

[Benjamin Herrenschmidt <benh@kernel.crashing.org>]

On Thu, 2008-01-24 at 00:38 -0600, Kumar Gala wrote:
> The common arch/powerpc code calls in to functions in setup-bus.c
> so some builds of ppc32 would fail.
> 
> Note, ppc32 usage of setup-irq.c is limited to arch/ppc and should be
> removed when arch/ppc goes away.
> 
> Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
> Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

Ack. Funny I didn't catch it on my 4xx testing, I must have always had
HOTPLUG enabled.

> ---
> 
> Here's the proper diff, will send this via paulus.
> 
>  drivers/pci/Makefile |    2 +-
>  1 files changed, 1 insertions(+), 1 deletions(-)
> 
> diff --git a/drivers/pci/Makefile b/drivers/pci/Makefile
> index 5550556..f697f3d 100644
> --- a/drivers/pci/Makefile
> +++ b/drivers/pci/Makefile
> @@ -32,7 +32,7 @@ obj-$(CONFIG_ARM) += setup-bus.o setup-irq.o
>  obj-$(CONFIG_PARISC) += setup-bus.o
>  obj-$(CONFIG_SUPERH) += setup-bus.o setup-irq.o
>  obj-$(CONFIG_PPC32) += setup-irq.o
> -obj-$(CONFIG_PPC64) += setup-bus.o
> +obj-$(CONFIG_PPC) += setup-bus.o
>  obj-$(CONFIG_MIPS) += setup-bus.o setup-irq.o
>  obj-$(CONFIG_X86_VISWS) += setup-irq.o
>