[PATCH] therm_adt746x: Always clear hardware bit which inverts fan speed range.

[PATCH] therm_adt746x: Always clear hardware bit which inverts fan speed range.

[Michel Dänzer]

This bit would get enabled sometimes (probably after suspend/resume), so the
fan would run at full speed below the temperature thresholds, but slow down and
eventually stop if temperatures rose above the thresholds... not exactly what
you want.

Signed-off-by: Michel Dänzer <michel@daenzer.net>
---
 drivers/macintosh/therm_adt746x.c |    4 +++-
 1 files changed, 3 insertions(+), 1 deletions(-)

diff --git a/drivers/macintosh/therm_adt746x.c b/drivers/macintosh/therm_adt746x.c
index 82607ad..321eaad 100644
--- a/drivers/macintosh/therm_adt746x.c
+++ b/drivers/macintosh/therm_adt746x.c
@@ -37,6 +37,7 @@
 #define CONFIG_REG   0x40
 #define MANUAL_MASK  0xe0
 #define AUTO_MASK    0x20
+#define INVERT_MASK  0x10
 
 static u8 TEMP_REG[3]    = {0x26, 0x25, 0x27}; /* local, sensor1, sensor2 */
 static u8 LIMIT_REG[3]   = {0x6b, 0x6a, 0x6c}; /* local, sensor1, sensor2 */
@@ -229,7 +230,8 @@ static void write_fan_speed(struct thermostat *th, int speed, int fan)
 	
 	if (speed >= 0) {
 		manual = read_reg(th, MANUAL_MODE[fan]);
-		write_reg(th, MANUAL_MODE[fan], manual|MANUAL_MASK);
+		write_reg(th, MANUAL_MODE[fan],
+			(manual|MANUAL_MASK) & (~INVERT_MASK));
 		write_reg(th, FAN_SPD_SET[fan], speed);
 	} else {
 		/* back to automatic */
-- 
1.6.3