From mboxrd@z Thu Jan 1 00:00:00 1970 Return-Path: Received: from SMTP.CITRIX.COM (smtp.citrix.com [66.165.176.89]) by ozlabs.org (Postfix) with ESMTP id A8441DDFBF for ; Fri, 29 May 2009 18:44:09 +1000 (EST) From: Ian Campbell To: Subject: Date: Fri, 29 May 2009 09:43:54 +0100 Message-ID: <1243586643-5554-1-git-send-email-ian.campbell@citrix.com> MIME-Version: 1.0 Content-Type: text/plain Cc: x86@kernel.org, Jeremy Fitzhardinge , Tony Luck , linux-ia64@vger.kernel.org, Ian Campbell , Olaf Kirch , Greg KH , FUJITA Tomonori , linuxppc-dev@ozlabs.org, Ingo Molnar List-Id: Linux on PowerPC Developers Mail List List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , This series: * removes the swiotlb_(arch_)_phys_to_bus and bus_to_phys __weak hooks, replacing them with an architecture-specific phys_to_dma and dma_to_phys interface. These are used by both PowerPC and Xen to provide the correct mapping from physical to DMA addresses. * removes the swiotlb_address_needs_mapping and swiotlb_range_needs_mapping __weak functions as well as is_buffer_dma_capable (which should never have been a generic function). All three are replaced by a single architecture-specific interface which meets the needs of both PowerPC and Xen. * removes the swiotlb_virt_to_bus __weak function and replaces it with a CONFIG_HIGHMEM compatible version when high memory is in use. This is needed for 32 bit PowerPC swiotlb support. I think these new interfaces are cleaner than the existing __weak functions and isolate the swiotlb code from architecture internals. This series does not contain any Xen or PowerPC specific changes, those will follow in separate postings. The complete patchset has been boot tested under Xen and native-x86 and compiled for IA64 and PowerPC Signed-off-by: Ian Campbell Cc: Becky Bruce Cc: Benjamin Herrenschmidt Cc: FUJITA Tomonori Cc: Greg KH Cc: Ingo Molnar Cc: Jeremy Fitzhardinge Cc: Kumar Gala Cc: Olaf Kirch Cc: Tony Luck Cc: linux-ia64@vger.kernel.org Cc: linuxppc-dev@ozlabs.org Cc: x86@kernel.org