[PATCH] mpic: fix Destination Registers init problem

[Zhao Chenhui <chenhui.zhao@freescale.com>]

The Freescale implementation of the MPIC only allows a single CPU
destination for non-IPI interrupts. Test the flag MPIC_SINGLE_DEST_CPU
to check if the Destination registers should be set.

This prevents more than one bit is set at secondary processors
initilizing time if the flag MPIC_SINGLE_DEST_CPU is set.

Signed-off-by: Zhao Chenhui <chenhui.zhao@freescale.com>
Signed-off-by: Li Yang <leoli@freescale.com>
---
 arch/powerpc/sysdev/mpic.c |    2 +-
 1 files changed, 1 insertions(+), 1 deletions(-)

diff --git a/arch/powerpc/sysdev/mpic.c b/arch/powerpc/sysdev/mpic.c
index 9c6e535..cc537f8 100644
--- a/arch/powerpc/sysdev/mpic.c
+++ b/arch/powerpc/sysdev/mpic.c
@@ -1675,7 +1675,7 @@ void mpic_setup_this_cpu(void)
 	 * it differently, then we should make sure we also change the default
 	 * values of irq_desc[].affinity in irq.c.
  	 */
-	if (distribute_irqs) {
+	if (distribute_irqs && !(mpic->flags & MPIC_SINGLE_DEST_CPU)) {
 	 	for (i = 0; i < mpic->num_sources ; i++)
 			mpic_irq_write(i, MPIC_INFO(IRQ_DESTINATION),
 				mpic_irq_read(i, MPIC_INFO(IRQ_DESTINATION)) | msk);
-- 
1.7.1