[PATCH] powerpc/85xx: p1025twr: add module conditional to fix QE-uart issue

[Pengbo Li <Pengbo.Li@freescale.com>]

From: Xie Xiaobo <X.Xie@freescale.com>

A ioport setting was needed when used the QE uart function on TWR-P1025.
Added a conditional definition to avoid missing this setting when the
QE-uart driver was bulit to a module.

Signed-off-by: Xie Xiaobo <X.Xie@freescale.com>
Change-Id: I95b40c760335ce5fa7a27a94287dbef28219b5fa
Reviewed-on: http://git.am.freescale.net:8181/6643
Tested-by: Review Code-CDREVIEW <CDREVIEW@freescale.com>
Reviewed-by: Yang Li <LeoLi@freescale.com>
Reviewed-by: Thomas Trefny <Tom.Trefny@freescale.com>
Reviewed-on: http://git.am.freescale.net:8181/12045
Reviewed-by: Jose Rivera <German.Rivera@freescale.com>
---
 arch/powerpc/platforms/85xx/twr_p102x.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/powerpc/platforms/85xx/twr_p102x.c b/arch/powerpc/platforms/85xx/twr_p102x.c
index 1eadb6d..069e19b 100644
--- a/arch/powerpc/platforms/85xx/twr_p102x.c
+++ b/arch/powerpc/platforms/85xx/twr_p102x.c
@@ -101,7 +101,7 @@ static void __init twr_p1025_setup_arch(void)
 					MPC85xx_PMUXCR_QE(12));
 			iounmap(guts);
 
-#if defined(CONFIG_SERIAL_QE)
+#if defined(CONFIG_SERIAL_QE) || defined(CONFIG_SERIAL_QE_MODULE)
 			/* On P1025TWR board, the UCC7 acted as UART port.
 			 * However, The UCC7's CTS pin is low level in default,
 			 * it will impact the transmission in full duplex
-- 
2.1.0.27.g96db324