[PATCH v2] powerpc/85xx: p1025twr: add module conditional to fix QE-uart issue

[Pengbo Li <Pengbo.Li@freescale.com>]

From: Xie Xiaobo <X.Xie@freescale.com>

A ioport setting was needed when used the QE uart function on TWR-P1025.
Added a conditional definition to avoid missing this setting when the
QE-uart driver was bulit to a module.

Signed-off-by: Xie Xiaobo <X.Xie@freescale.com>
Signed-off-by: Li Pengbo <Pengbo.Li@freescale.com>
---
 arch/powerpc/platforms/85xx/twr_p102x.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/powerpc/platforms/85xx/twr_p102x.c b/arch/powerpc/platforms/85xx/twr_p102x.c
index 1eadb6d..30e002f 100644
--- a/arch/powerpc/platforms/85xx/twr_p102x.c
+++ b/arch/powerpc/platforms/85xx/twr_p102x.c
@@ -79,7 +79,7 @@ static void __init twr_p1025_setup_arch(void)
 	mpc85xx_qe_init();
 	mpc85xx_qe_par_io_init();
 
-#if defined(CONFIG_UCC_GETH) || defined(CONFIG_SERIAL_QE)
+#if IS_ENABLED(CONFIG_UCC_GETH) || IS_ENABLED(CONFIG_SERIAL_QE)
 	if (machine_is(twr_p1025)) {
 		struct ccsr_guts __iomem *guts;
 
@@ -101,7 +101,7 @@ static void __init twr_p1025_setup_arch(void)
 					MPC85xx_PMUXCR_QE(12));
 			iounmap(guts);
 
-#if defined(CONFIG_SERIAL_QE)
+#if IS_ENABLED(CONFIG_SERIAL_QE)
 			/* On P1025TWR board, the UCC7 acted as UART port.
 			 * However, The UCC7's CTS pin is low level in default,
 			 * it will impact the transmission in full duplex
-- 
2.1.0.27.g96db324