[PATCH v2] powerpc/perf: Fix kernel address leaks via Sampling registers

[Madhavan Srinivasan <maddy@linux.vnet.ibm.com>]

From: Michael Ellerman <mpe@ellerman.id.au>

Current code in power_pmu_disable() does not clear the sampling
registers like Sampling Instruction Address Register (SAIR) and
Sampling Data Address Register (SDAR) after disabling the PMU.
Since these are userspace readable and could contain kernel
address, add code to explicitly clear the content of these registers.
Patch also adds a "context synchronizing instruction" to enforce
no further updates to these registers as mandated by PowerISA.

"If an mtspr instruction is executed that changes the
value of a Performance Monitor register other than
SIAR, SDAR, and SIER, the change is not guaranteed
to have taken effect until after a subsequent context
synchronizing instruction has been executed (see
Chapter 11. "Synchronization Requirements for Con-
text Alterations" on page 1133)."

Signed-off-by: Madhavan Srinivasan <maddy@linux.vnet.ibm.com>
---
Changelog v1:
  - Added config flags to avoid 32bit build breaks.

 arch/powerpc/perf/core-book3s.c | 15 +++++++++++++++
 1 file changed, 15 insertions(+)

diff --git a/arch/powerpc/perf/core-book3s.c b/arch/powerpc/perf/core-book3s.c
index f89bbd54ecec..39846226c702 100644
--- a/arch/powerpc/perf/core-book3s.c
+++ b/arch/powerpc/perf/core-book3s.c
@@ -1226,6 +1226,7 @@ static void power_pmu_disable(struct pmu *pmu)
 		 */
 		write_mmcr0(cpuhw, val);
 		mb();
+		isync();
 
 		/*
 		 * Disable instruction sampling if it was enabled
@@ -1234,12 +1235,26 @@ static void power_pmu_disable(struct pmu *pmu)
 			mtspr(SPRN_MMCRA,
 			      cpuhw->mmcr[2] & ~MMCRA_SAMPLE_ENABLE);
 			mb();
+			isync();
 		}
 
 		cpuhw->disabled = 1;
 		cpuhw->n_added = 0;
 
 		ebb_switch_out(mmcr0);
+
+#ifdef CONFIG_PPC64
+		/*
+		 * These are readable by userspace, may contain kernel
+		 * addresses and are not switched by context switch, so clear
+		 * them now to avoid leaking anything to userspace in general
+		 * including to another process.
+		 */
+		if (ppmu->flags & PPMU_ARCH_207S) {
+			mtspr(SPRN_SDAR, 0);
+			mtspr(SPRN_SIAR, 0);
+		}
+#endif
 	}
 
 	local_irq_restore(flags);
-- 
2.7.4