From mboxrd@z Thu Jan 1 00:00:00 1970 Message-Id: <199901152240.QAA07784@lists.linuxppc.org> Date: Fri, 15 Jan 1999 17:40:47 -0500 (EST) From: "Jim Somerville" Reply-To: "Jim Somerville" Subject: Re: MCP750 and CPX2000 System Scsi Woes To: Gabriel Paubert cc: linuxppc-dev@lists.linuxppc.org, valette@crf.canon.fr, "Corey Minyard" MIME-Version: 1.0 Content-Type: text/plain; charset=iso-8859-1 Sender: owner-linuxppc-dev@lists.linuxppc.org List-Id: In message "Re: MCP750 and CPX2000 System Scsi Woes", "Gabriel Paubert" writes: >Not very surprising, which is the actual interrupt used for SCSI >(it should be in the doc and in the residual data). > >Tell me if the zImage-2.2.0-pre5 on ftp://vcorr1.iram.es/pub/ works >better. Early boot messages will be different and it will try to use >the OpenPIC (that's the image running on my MVME2600 right now). >I'm completely reorganizing my source code and patches, hopefully >I'll be able to make it available during the week-end. Gabriel, it worked! SCSI devices were found successfully. It died at the end trying to mount the non-existent root partition. If you have a ramdisk image that contains an installer, it would be appreciated. :-) I'll look for your source on Monday. Thanks again, -Jim [[ This message was sent via the linuxppc-dev mailing list. Replies are ]] [[ not forced back to the list, so be sure to Cc linuxppc-dev if your ]] [[ reply is of general interest. To unsubscribe from linuxppc-dev, send ]] [[ the message 'unsubscribe' to linuxppc-dev-request@lists.linuxppc.org ]]