From mboxrd@z Thu Jan 1 00:00:00 1970 Date: Wed, 28 Jul 1999 10:09:51 +1000 Message-Id: <199907280009.KAA01751@tango.anu.edu.au> From: Paul Mackerras To: geiseri@msoe.edu CC: linuxppc-dev@lists.linuxppc.org, linuxppc-user@lists.linuxppc.org In-reply-to: <379E3513.738D0449@msoe.edu> (message from ian geiser on Tue, 27 Jul 1999 17:39:15 -0500) Subject: Re: G3 Upgrade Questions.... Reply-to: Paul.Mackerras@cs.anu.edu.au References: <379E3513.738D0449@msoe.edu> Sender: owner-linuxppc-dev@lists.linuxppc.org List-Id: ian geiser wrote: > I just installed a G3 upgrade card into my powercenter132 > It is a 400Mhz with 1Meg at 200Mhz.... > It registers under MacOS perfectly but i get the following under > proc/cpuinfo: > processor : 0 > cpu : 750 > temperature : 0 C <--Is this correct?! Yeah, reading the temperature isn't actually implemented yet. > clock : 195MHz <-- Is this correct?! That is probably the value from Open Firmware. I would guess that OF on your motherboard doesn't know how to work out the clock frequency correctly for the G3. It doesn't matter, though. Paul. [[ This message was sent via the linuxppc-dev mailing list. Replies are ]] [[ not forced back to the list, so be sure to Cc linuxppc-dev if your ]] [[ reply is of general interest. Please check http://lists.linuxppc.org/ ]] [[ and http://www.linuxppc.org/ for useful information before posting. ]]