From mboxrd@z Thu Jan 1 00:00:00 1970 In-Reply-To: Date: Tue, 24 Aug 1999 11:06:02 +0200 To: Tony Mantler , linuxppc-dev@lists.linuxppc.org From: Benjamin Herrenschmidt Subject: Re: Performa 5200 Message-Id: <19990824110602.000653@mail.mipsys.com> Mime-Version: 1.0 Content-Type: text/plain; charset=US-ASCII Sender: owner-linuxppc-dev@lists.linuxppc.org List-Id: On Tue, Aug 24, 1999, Tony Mantler wrote: >I recently obtained for myself up a Performa 5200, and I've been playing >with trying to hack linux into shape on it. (I'm usually a Mac68k guy) > >I compiled a kernel from a stock 2.2.10 tree that I have laying around >(from ftp.kernel.org, most every config option turned off, booting with >BootX) and, after sprinkling around a bit of debug code, found that it >makes it past the prom.c code where it draws the "Welcome to linux >[blahblah] booting...", but doesn't make it to start_kernel after that. > >I'm not particularily fluent in PPC ASM, so head.S makes fairly opaque >reading for me. I'm wondering if someone might have some pointers to where >this would likely be dying, so I have good a place to start? is this a NuBus class machine or a PCI based one ? If it's a NuBus one, then you are out of luck, or if you have time to spend, you can begin porting linux/ppc to those beasts. (Basically, RAM is not contiguous and you cannot rely in the kernel beeing loaded at physical 0, since the frame buffer may be hard coded at physical 1Mb). Look at the various parameters BootX pass for a NuBus machine (using the latest 2.1.12 kernel from vger or Paul's rsync, you should have the latest bootx.h). -- Perso. e-mail: Work e-mail: BenH. Web : [[ This message was sent via the linuxppc-dev mailing list. Replies are ]] [[ not forced back to the list, so be sure to Cc linuxppc-dev if your ]] [[ reply is of general interest. Please check http://lists.linuxppc.org/ ]] [[ and http://www.linuxppc.org/ for useful information before posting. ]]