From: Madhavan Srinivasan <maddy@linux.ibm.com>
To: Christian Zigotzky <chzigotzky@xenosoft.de>,
Michael Ellerman <mpe@ellerman.id.au>
Cc: Ritesh Harjani <ritesh.list@gmail.com>,
npiggin@gmail.com, linuxppc-dev@lists.ozlabs.org,
info@xenosoft.de, Darren Stevens <darren@stevens-zone.net>,
"R.T.Dickinson" <rtd2@xtra.co.nz>,
Damien Stewart <hypexed@yahoo.com.au>
Subject: Re: [PATCH] powerpc/pasemi: Defer Nemo IRQ initialization
Date: Tue, 10 Nov 2026 12:00:55 +0530 [thread overview]
Message-ID: <1bd2597a-4873-4f99-b29e-d5e74ed45b22@linux.ibm.com> (raw)
In-Reply-To: <E1BAC41D-33BA-4A27-8549-6A885489A59E@xenosoft.de>
On 11/10/26 11:09 AM, Christian Zigotzky wrote:
>
>> On 02 November 2026 at 04:39 am, Ritesh Harjani <ritesh.list@gmail.com> wrote:
>>
>> chzigotzky@xenosoft.de writes:
>>
>>> From: Christian Zigotzky A-EON Open Source <info@xenosoft.de>
>>>
>>> Since pas_pci_init() is now called later during boot, the i8259
>>> initialization in pas_init_IRQ() happens too early and accesses
>>> registers that are not yet mapped, preventing the board from booting.
>>>
>>> Move the Nemo-specific i8259 initialization to pas_add_bridge(),
>>> after the ISA bridge has been discovered.
>>
>> That make sense to me. The patch looks good. However, shouldn't we also
>> add Fixes tag and Cc: stable tag - so that this gets backported to older
>> stable kernels.
>>
>>
>> Fixes: c144bc719234 ("powerpc/pasemi: Move PHB discovery")
>> Cc: stable@vger.kernel.org
>>
>> I think the fixes tag should be above - but feel free to correct that.
>>
>> Otherwise looks good to me. Feel free to add:
>> Reviewed-by: Ritesh Harjani (IBM) <ritesh.list@gmail.com>
>>
>>
>>> Suggested-by: Darren Stevens <darren@stevens-zone.net>
>>> Tested-by: Christian Zigotzky <chzigotzky@xenosoft.de>
>>> Signed-off-by: Christian Zigotzky A-EON Open Source <info@xenosoft.de>
>>> ---
>>> arch/powerpc/platforms/pasemi/pasemi.h | 6 ++++++
>>> arch/powerpc/platforms/pasemi/pci.c | 5 +++++
>>> arch/powerpc/platforms/pasemi/setup.c | 12 ++++--------
>>> 3 files changed, 15 insertions(+), 8 deletions(-)
>>>
>>> diff --git a/arch/powerpc/platforms/pasemi/pasemi.h b/arch/powerpc/platforms/pasemi/pasemi.h
>>> index 6f6743b8e48d..01bcfa258625 100644
>>> --- a/arch/powerpc/platforms/pasemi/pasemi.h
>>> +++ b/arch/powerpc/platforms/pasemi/pasemi.h
>>> @@ -7,6 +7,12 @@ extern void pas_pci_init(void);
>>> struct pci_dev;
>>> extern void pas_pci_dma_dev_setup(struct pci_dev *dev);
>>>
>>> +#ifdef CONFIG_PPC_PASEMI_NEMO
>>> +void __init nemo_init_IRQ(void);
>>> +#else
>>> +static inline void __init nemo_init_IRQ(void) { }
>>> +#endif
>>> +
>>> void __iomem *__init pasemi_pci_getcfgaddr(struct pci_dev *dev, int offset);
>>>
>>> extern void __init pasemi_map_registers(void);
>>> diff --git a/arch/powerpc/platforms/pasemi/pci.c b/arch/powerpc/platforms/pasemi/pci.c
>>> index 2df955274652..fb53782da7ec 100644
>>> --- a/arch/powerpc/platforms/pasemi/pci.c
>>> +++ b/arch/powerpc/platforms/pasemi/pci.c
>>> @@ -265,6 +265,11 @@ static int __init pas_add_bridge(struct device_node *dev)
>>> */
>>> isa_bridge_find_early(hose);
>>>
>>> + /*
>>> + * ISA bridge is now active, add the i8259 cascade (if needed)
>>> + */
>>> + nemo_init_IRQ();
>>> +
>>> return 0;
>>> }
>>>
>>> diff --git a/arch/powerpc/platforms/pasemi/setup.c b/arch/powerpc/platforms/pasemi/setup.c
>>> index 45792ecd5dfd..7a961f2a228f 100644
>>> --- a/arch/powerpc/platforms/pasemi/setup.c
>>> +++ b/arch/powerpc/platforms/pasemi/setup.c
>>> @@ -216,10 +216,12 @@ static void sb600_8259_cascade(struct irq_desc *desc)
>>> chip->irq_eoi(&desc->irq_data);
>>> }
>>>
>>> -static void __init nemo_init_IRQ(struct mpic *mpic)
>>> +void __init nemo_init_IRQ(void)
>>> {
>>> struct device_node *np;
>>> int gpio_virq;
>>> + struct mpic *mpic;
>>> +
>>> /* Connect the SB600's legacy i8259 controller */
>>> np = of_find_node_by_path("/pxp@0,e0000000");
>>> i8259_init(np, 0);
>>> @@ -230,14 +232,10 @@ static void __init nemo_init_IRQ(struct mpic *mpic)
>>> irq_set_chained_handler(gpio_virq, sb600_8259_cascade);
>>> mpic_unmask_irq(irq_get_irq_data(gpio_virq));
>>>
>>> + mpic = irq_get_chip_data(gpio_virq);
>>> irq_set_default_domain(mpic->irqhost);
>>> }
>>>
>>> -#else
>>> -
>>> -static inline void nemo_init_IRQ(struct mpic *mpic)
>>> -{
>>> -}
>>> #endif
>>>
>>> static __init void pas_init_IRQ(void)
>>> @@ -300,8 +298,6 @@ static __init void pas_init_IRQ(void)
>>> mpic_unmask_irq(irq_get_irq_data(nmi_virq));
>>> }
>>>
>>> - nemo_init_IRQ(mpic);
>>> -
>>> of_node_put(mpic_node);
>>> of_node_put(root);
>>> }
>>> --
>>> 2.43.0
> Hi Michael,
>
> I would like to ask about the status of my patch.
Yes, this is parked for the fixes tree.
Maddy
> The patch received a positive review from Ritesh Harjani.
> This fix is important for our Nemo boards, otherwise fails to boot with recent kernels.
>
> Thanks,
> Christian
next prev parent reply other threads:[~2026-11-10 6:31 UTC|newest]
Thread overview: 7+ messages / expand[flat|nested] mbox.gz Atom feed top
2026-10-24 7:55 [PATCH] powerpc/pasemi: Defer Nemo IRQ initialization chzigotzky
2026-10-28 3:53 ` Christian Zigotzky
2026-11-02 3:34 ` Ritesh Harjani
2026-11-02 5:20 ` Christian Zigotzky
2026-11-10 5:39 ` Christian Zigotzky
2026-11-10 6:30 ` Madhavan Srinivasan [this message]
-- strict thread matches above, loose matches on Subject: below --
2026-09-28 11:04 [PATCH 0/2] KVM: PPC: BookE: Fix boot hang on preemptible kernels Shrikanth Hegde
2026-09-28 11:04 ` [PATCH 1/2] KVM: PPC: BookE: Disable preemption before loading guest FP and Altivec Shrikanth Hegde
2026-10-01 11:26 ` Narayana Murty N
2026-10-01 11:53 ` Shrikanth Hegde
2026-10-30 16:21 ` Ritesh Harjani
2026-11-01 11:35 ` [PATCH] powerpc/pasemi: Defer Nemo IRQ initialization Christian Zigotzky
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1bd2597a-4873-4f99-b29e-d5e74ed45b22@linux.ibm.com \
--to=maddy@linux.ibm.com \
--cc=chzigotzky@xenosoft.de \
--cc=darren@stevens-zone.net \
--cc=hypexed@yahoo.com.au \
--cc=info@xenosoft.de \
--cc=linuxppc-dev@lists.ozlabs.org \
--cc=mpe@ellerman.id.au \
--cc=npiggin@gmail.com \
--cc=ritesh.list@gmail.com \
--cc=rtd2@xtra.co.nz \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox