Re: ide_dmaproc - YaBoot

[Michel Lanners <mlan@cpu.lu>]

Hi there,

On  28 May, this message from Henning Loeser echoed through cyberspace:
> Something else seems to be fishy aswell maybe the driver (???) or
> whatever. I went ahead and tried a new 2.4.0test1-ac1 kernel and all of
> the sudden the driver doesn't even see the drive any more ... :
> AEC6260R: IDE controller on PCI bus 00 dev 68
> AEC6260R: chipset revision 1
> AEC6260R: not 100% native mode: will probe irqs later
> AEC6260R: ROM enabled at 0x80810000
> AEC6260: reg49h=0x00 ATA-66 Cable Port0
>     ide0: BM-DMA at 0x0800-0x0807, BIOS settings: hda:pio, hdb:pio
> AEC6260: reg49h=0x00 ATA-66 Cable Port1
>     ide1: BM-DMA at 0x0808-0x080f, BIOS settings: hdc:pio, hdd:pio
> hda: ZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZ, ATA DISK drive
> ide0 at 0x840-0x847,0x000 on irq 23
          ^^^^^^^^^^^
You're not using my PCI patches. I'm amazed it finds anything at all on
your card; but anyway, get my latest 2.3.99 patches (2.3.99-pre9, that
is), and apply them. From the above, it seems only part of the
communication of the card with the driver works ok, whereas the rest
reads schrott.

Michel

-------------------------------------------------------------------------
Michel Lanners                 |  " Read Philosophy.  Study Art.
23, Rue Paul Henkes            |    Ask Questions.  Make Mistakes.
L-1710 Luxembourg              |
email   mlan@cpu.lu            |
http://www.cpu.lu/~mlan        |                     Learn Always. "


** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/