From mboxrd@z Thu Jan 1 00:00:00 1970 Date: Sat, 27 Jan 2001 19:59:24 -0500 From: Daniel Eisenbud To: Michael Schmitz Cc: Michael Schmitz , Amit Chaudhary , linuxppc-dev@lists.linuxppc.org Subject: Re: mesh SCSI bus locks hard on 7500 when burning a CD-R in dao mode Message-ID: <20010127195924.A19744@allspice.cs.swarthmore.edu> References: <20010126160441.B16573@allspice.cs.swarthmore.edu> <20010127163115.B2695@allspice.cs.swarthmore.edu> Mime-Version: 1.0 Content-Type: text/plain; charset=us-ascii In-Reply-To: <20010127163115.B2695@allspice.cs.swarthmore.edu>; from eisenbud@cs.swarthmore.edu on Sat, Jan 27, 2001 at 04:31:15PM -0500 Sender: owner-linuxppc-dev@lists.linuxppc.org List-Id: On Sat, Jan 27, 2001 at 04:31:15PM -0500, Daniel Eisenbud wrote: > On Fri, Jan 26, 2001 at 10:32:35PM +0100, Michael Schmitz wrote: > > # same to a separate screen > > *.info;mail.none;authpriv.none;local0.none /dev/tty7 > > > > is what keeps a not-too-cluttered log (copy of /var/log/messages) on tty7 > > of our server. kern.notice to some tty would probably be enough for you. > > > > > and not to any files so syslogd won't freeze when SCSI goes? Is there > > > > So put just that one line redirecting log output to /dev/tty7 into > > syslog.conf temporarily and kill -1 syslogd before starting the test. > > I'll try this variation in a few minutes. This worked, but I didn't get any useful log output until I started getting error 600 from the SCSI midlevel and errors from ext2fs. I'm going to try again, making sure that I have dmesg set as high as possible, and see if I can get anything else. Otherwise, is it time to start scattering printk()'s around the mesh driver? -Daniel -- Daniel E. Eisenbud eisenbud@cs.swarthmore.edu ** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/