From mboxrd@z Thu Jan 1 00:00:00 1970 To: joakim.tjernlund@lumentis.se Cc: linuxppc-embedded@lists.linuxppc.org Subject: Re: gdb problems From: Wolfgang Denk Mime-version: 1.0 Content-type: text/plain; charset=ISO-8859-1 In-reply-to: Your message of "Thu, 10 May 2001 19:19:07 +0200." Date: Thu, 10 May 2001 19:40:53 +0200 Message-Id: <20010510174058.CF2942814D@denx.denx.de> Sender: owner-linuxppc-embedded@lists.linuxppc.org List-Id: In message you wrote: > > I am trying to debug ppclinux 2.4 and ppcboot on RPX CLLF board > connected to an Abatron emulator. Did you invalidate the M_TWB in the BDI config file ("WSPR 796 0"), and did you enable address translation ("MMU XLAT") ? > When I print variables in gdb I get an message And what was the EXACT error message? > instead of the variable value. Breakpoints and stack trace etc. works > fine. I have enabled -g switch to gcc. Which version of GDB are you using, and which firmware version of the BDI2000? (b20ppcgd.108 has been out for some time). Wolfgang Denk -- Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-4596-87 Fax: (+49)-8142-4596-88 Email: wd@denx.de The typical page layout program is nothing more than an electronic light table for cutting and pasting documents. ** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/