* mppmc8240:how to turn PROGMODE mode on?
@ 2002-01-17 10:37 邹涛
0 siblings, 0 replies; only message in thread
From: 邹涛 @ 2002-01-17 10:37 UTC (permalink / raw)
To: linuxppc-embedded@lists.linuxppc.org
hello:
i use sandpoint3 and mppmc8240(unity ). When i use fupdate to write linux kernel into flash.
DINK32_KAHLUA >>fu -l 100000 FF700000 100000
PPMC Local Flash Programmer
Are you sure? y
Check flash type: Unknown, Manu. 90, Device 4c
Make sure the PROGMODE switch is ON
ERROR : FLASH error.
i read the unity_x2.pdf carefully. but i can't find the PROGMODE switch.There are only two
switch on the process board. One is sw2 ,the other is sw3. The sw2 is
"system speed setting" .My setting is "01111",(1 means on,right). the sw3 is "user configuration
setting". My setting is "10010"
position value mean
sw3-1 1 pci bus ROM location
sw3-2 0 independant free agent
sw3-3 0 map B(chrp) memory map
sw3-4 1 enable debug
sw3-5 0 disable local reset
Do i ignore something? Could you give me some advice? Thanks for you help.
stone@pocketix.com
2002-01-17
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
^ permalink raw reply [flat|nested] only message in thread
only message in thread, other threads:[~2002-01-17 10:37 UTC | newest]
Thread overview: (only message) (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2002-01-17 10:37 mppmc8240:how to turn PROGMODE mode on? 邹涛
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).